The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

Graham Stewart



removing tabernacle - using heat to remove 5200

2020-10-28; 22:32:40 EDT

Member Since

2005-04-29

Posts: 814

I had the situation Luis described when I had to remove the centerboard cap back in about 1996. I realize now that it had been installed with 5200 or equivalent but didn't know about that stuff back then. I managed to get it off by heating a large knife to red hot and inserting it into the sealant and slowly slicing along the length of the joint. It worked but took forever as I had to reheat the knife after about a minute and could make very little progress in that time. It was a huge effort. Even so I broke the cap in two in the process. 

I didn't try to heat the fiberglass directly and would be very reluctant to do that now as I think it unlikely that you could get sufficient heat into the join without destroying the fiberglass. It was a huge miserable job. Today if I were faced with this problem I would rely on Debond and then track down the person who used the 5200 and hold his head under water for awhile.

Graham Stewart
Agile, Rodes 22, 1976
Kingston Ontario


See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting