The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

ROGER PIHLAJA



Rhodes 22 Safety Tether System & Winter Projects

2020-11-25; 07:17:32 EST

Member Since

2002-08-01

Posts: 1438

I thought about a safety tether system using a jack line on the centerline of the boat.  But, on the bow, you have the issue of how to anchor the end so it doesn’t interfere with roller furler.  In my case, I suppose I could have anchored the bow end of the jack line to a thru-bolted padeye I installed for the tack on my cruising spinnaker.  It’s far enough aft of the bow to not interfere with the roller furler and it’s control line.  Going aft, you  could anchor the jack line to the halyard organizer at the mast step.  But, I want to be able to clip onto the jack line before I leave the cockpit and having the jack line end at the mast step leaves several hazardous steps with no connected safety harness.  Aft of the mast step, you are kind of out of good options.  You can’t anchor the jack line to anything on the pop top because it’s not fastened down and not HD enough anyway.  If you go all the way aft to the stern pulpit, then the jack line runs down the length of the cockpit right at chest level, plus it interferes with the boom vang, the tiller, the mainsheet traveler, and mainsheets to say nothing of the crew.

By running my jack lines up the port and starboard side decks from the cockpit to the base of the bow pulpit, I avoid all these issues.  The only disadvantage to my system is that if you go over on the side you are clipped into, the tether has quite a bit of slack and can leave you hanging.  But my railings are 30” high and I go forward in a crouch so I stay low.  Of course, you normally go forward on the windward side of the boat.  So, as long as the boat doesn’t broach, you are likely to be OK.

A jack line running up the centerline would be ideal.  So, inquiring minds want to know, how did you rig a jack line on the centerline of your Rhodes 22?

Roger Pihlaja
S/V Dynamic Equilibrium

Sent from Mail<https://go.microsoft.com/fwlink/?LinkId=550986> for Windows 10

From: ROGER PIHLAJA<mailto:roger_pihlaja at msn.com>
Sent: Tuesday, November 24, 2020 5:34 PM
To: The Rhodes 22 Email List<mailto:rhodes22-list at rhodes22.org>
Subject: Rhodes 22 Safety Tether System & Winter Projects

Tom,

Unfortunately, S/V Dynamic Equilibrium is in winter storage.  I don’t think I have any photos of the safety tether system.  It’s a pretty standard arrangement for offshore monohull sailboats and I never thought to take a picture of it.  I store the boat at the Midland Co. Fairgrounds in the unused animal barns and vender buildings.  For Midland Co. residents, the price is right, especially considering it’s secure indoor storage.  But, I don’t have access to the boat until next spring.

This winter’s projects will be to fabricate a new galley table and under cabinet sliding doors.  Both of these components are original (1976) and delaminating on my boat.  I’ve asked Stan about purchasing a new table and doors several times.  But, so far, he hasn’t responded to my queries.  I’d like to support his replacement parts business. But, when he doesn’t respond, what can you do?

Roger Pihlaja
S/V Dynamic Equilibrium

Sent from my iPhone

See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting