2021-01-14; 12:22:35 EST
Member Since
2019-06-04
Posts: 463
Hi Rueben, I had similar concerns. The motor lift winch that came on my boat was only operated by a single remote and it was starting to exhibit inconsistency (occasionally slow to start/stop). Others had posted about adding a hard wired switch and/or replacing the remote, but I found it easiest to replace the entire winch with one that had a wired switch and two remotes. I keep one remote stowed in the port side cockpit coaming compartment, attached via velcro to a spot just above the opening and attached with a retractable cable so it can't fall overboard. The other remote is stowed in a ziploc bag in the sliding doors on top of the galley. The hard wired switch is now mounted to an HDPE block in the opening between the lazarette and the underside of the port side cockpit bench (where the fuel line comes through) just above the board I used to mount my spare anchor in the front side of the lazarette. I normally use the wired switch. This fall I made some changes to the wired switch mounting and how the wires are organized/protected in the lazarette but you can see the rest of my motor lift project from fall 2019 documented at: http://rhodes-22.1065344.n5.nabble.com/Replacement-of-winch-for-motor-lift-td56157.html#none Others on this group have various versions of the manual lift from GB which seems to get good reviews, or have improvised their own. I like my current setup, but next fall I plan to add a backup manual hoist which could be easily put in place in case the electric lift was not working. Regarding your other question, pulling on the knob on the motor does allow it to spin freely and that appears to be a normal feature of most of these types of winches. Good luck! Jesse Shumaker S/V ZephyrSee the original archive post