The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

Peter Nyberg



Tiller Pilot Recommendations

2021-02-18; 17:29:51 EST

Member Since

2016-04-14

Posts: 711

I have the Raymarine ST1000.  Actually, I depend on it so heavily, that I have two.  I have had one stop working.  I sent it back to Raymarine and they fixed it a no cost.

Attached is a document created by Bill Wickman about his installation of the ST1000.  I followed this pretty closely.  However, at the point where the tiller pilot attaches to the cockpit combing, he said he found the fiberglass to be thick, and needed no reinforcement.  I found the fiberglass to be quite thin at the point, and epoxied in a block of 3/4” thick hardwood.

I have no experience with the Simrad.

Good luck with your project.

Peter Nyberg
Coventry, CT
s/v Silverheels (1988/2016)

TillerPilotSetuponRhodes22.pdf

See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting