On Thu, Feb 18, 2021 at 5:30 PM Peter Nyberg <peter at sunnybeeches.com> wrote:
> I have the Raymarine ST1000. Actually, I depend on it so heavily, that I
> have two. I have had one stop working. I sent it back to Raymarine and
> they fixed it a no cost.
>> Attached is a document created by Bill Wickman about his installation of
> the ST1000. I followed this pretty closely. However, at the point where
> the tiller pilot attaches to the cockpit combing, he said he found the
> fiberglass to be thick, and needed no reinforcement. I found the
> fiberglass to be quite thin at the point, and epoxied in a block of 3/4”
> thick hardwood.
>> I have no experience with the Simrad.
>> Good luck with your project.
>> Peter Nyberg
> Coventry, CT
> s/v Silverheels (1988/2016)
> -------------- next part --------------
> A non-text attachment was scrubbed...
> Name: TillerPilotSetuponRhodes22.pdf
> Type: application/pdf
> Size: 786461 bytes
> Desc: not available
> URL: <
>http://rhodes22.org/pipermail/rhodes22-list/attachments/20210218/fdaa4e04/attachment.pdf> >
> -------------- next part --------------
>>>> > On Feb 18, 2021, at 5:13 PM, MichaelM <mm.bizlist1 at gmail.com> wrote:
> >
> > I'm hoping to install a Raymarine or Simrad tiller pilot in my boat.
> >
> > Can you share your experience with either unit and what challenges if any
> > did you encountered during the installation?
> >
> > Thanks!
> >
> > Mike McKay
> > s/v Liber 2006/2018
> >
> >
> >
> > --
> > Sent from: http://rhodes-22.1065344.n5.nabble.com/>>
--
Michael McKay (mm.bizlist1 at gmail.com)
×
Message to Webmaster:
To use your email application to send a messsage to the webmaster rather than this form,
.