The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

ROGER PIHLAJA



Compression Post and Head Door Problems

2021-02-23; 09:35:57 EST

Member Since

2002-08-01

Posts: 1438

Allyn,

Are you certain your compression post ends at the top of the vinyl floor?  My compression post goes all the way to the bottom of the bilge.  Open up the bilge inspection grate in the galley.  You should see the bottom of the compression post. The only way a compression post could be as you describe is if there is also some sort of support structure under the cabin sole.  This support would transfer the load from the compression post to the hull.  Assuming this is the case; then, perhaps your under cabin sole support structure has a problem, like dry rot.  The solution would be to replace the rotted pieces/parts under the cabin sole.  I doubt the compression post itself needs to be replaced, especially if it ends at the cabin sole.  You would need to pull up the cabin sole and start replacing bad wood.

Roger Pihlaja
S/V Dynamic Equilibrium 

Sent from my iPhone

See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting