< prior
Back to Month
Go to Thread
2021-03-09; 12:00:36 EST
Member Since
2019-04-22
Posts: 24
My pulpit is leaky as well, so I'm going to have to do this. Many thanks for the detailed description. Any chance you have a link to the video you found useful? Also, now that you've done it, would you have to cut the electrical cords to use the butyl tape? -- John Carlson Lillipelli (2004/2012)See the original archive post
> On Mar 9, 2021, at 10:25 AM, Reuben Mezrich <reuben.mezrich at gmail.com> wrote: > > After receiving the many excellent suggestions on where to look for leaks I > started what ended being a 1 week process to find and ultimately repair the > leak. > > I first removed the cosmetic wood trim inside the forward cabin at the bow > to expose the attachments of the Jib chainplate and the Bow eye. I sprayed > water at the bow and determined these were not the source of the leaks. I > then sprayed water on the foredeck and initially saw no water leaking into > the boat but when I came back to the boat the next morning found that some > water (about 1 - 2 cups) had collected at the bow (By now I had removed the > cushions and so could see the water in a puddle on the floor of the forward > bunk at the bow). I had some sort of a slow leak. > > I then had my wife spray water on the foredeck while I was on my back in > the forecabin and was able to see that there were leaks at each of the four > legs of the pulpit. The leaks would drip onto the carpeted shelf that is at > each side of the forecabin (behind a white fiberglass trim piece) and then > the water would slowly make its way forward to trickle down at the bow end > of the forecabin. > > The pulpit is attached by 3/8" bolts that are welded to each of the legs > and which extend down through holes in the deck and fastened with a flat > washer, lock washer and 9/16" nut. After unfastening the nuts the pulpit > lifted up easily. One complication is that the electrical wires that feed > the navigation lights at the bow extend through a seperate hole just > forward of the hole for the aft-starboard bolt. That wire seems to run back > to the distribution panel and has very little slack and so I had to cut > it. When I did remove the pulpit I found there was some white sealant that > adhered to the deck but not the pulpit leg (which ends in an oval flange at > the bottom) as well as an O-ring around the base of the bolt. > > After consulting with Stan, who told me that his preferred method for > keeping water out is to just use an O-ring around the nut (and not to apply > sealant), I cleaned off the old sealant (a product called ReMov which was > recommended in a Practical Sailor review, worked great for this) I put new > O-rings on. Rather than putting an O-ring around the electric wire near the > aft-starboard leg I put some wraps of butyl rubber tape abound it. > I reattached the pulpit, tightened the nuts and had my wife spray the > foredeck again and sadly found that there was again a leak (perhaps even > worse than before) at each leg - but not where the electric wire entered > the cabin. > > I removed the pulpit again, removed the o_rings and this time used Butyl > tape to form the seal at each leg. Using a technique I found on You Tube I > cut a 3 - 4 inch length of the tape, rolled the tape along its length into > a tube (or rope) and then wrapped it several times about the base of the > bolt. The thickness can be adjusted by adding more or less wraps and I was > generous, using the entire 3 - 4 inch tape at each leg. I added more Butyl > to the electric wire. > > After putting the pulpit back in place and only moderately tightening the > nuts, my wife sprayed the foredeck again and this time - success - no > leaks!! > > I have become a big fan of Butyl rubber tape, which to be honest I hadn't > even heard about till last week! > > Of course now I have to splice back the electric wire for the navigation > light and replace the cosmetic wood trim I removed, but I am much relieved > that this problem is solved > > Thanks for your advice and support > > --Reuben > Reuben Mezrich > Pelican Cove in Sarasota > Cell: 410-499-8922 > > > On Tue, Mar 2, 2021 at 12:49 PM <cjlowe at sssnet.com <mailto:cjlowe at sssnet.com>> wrote: > >> I like to tape paper towels around the suspected areas and see which ones >> show moisture first, then investigate further from there . >> >> >> Jerry Lowe >> S/V Country Rhodes '86 >> >> >> >> >> >>> Roger, Rob and Mike >>> Thanks for the good suggestions. I'll start by taking off that >> cosmeticsus >>> piece of wood at the bow and see what's behind. If nothing is loose I"ll >>> have someone aim a hose at the bow while I"m inside watching in the hope >>> that I might actually see where the water is getting in. >>> I really do hope I don't have to rebed everything. >>> Probably won't be able to do this till the weekend..I"ll report back on >>> what I find >>> >>> Reuben Mezrich >>> Pelican Cove in Sarasota >>> Cell: 410-499-8922 >>> >>> >>> On Mon, Mar 1, 2021 at 5:15 PM Michael D. Weisner <mweisner at ebsmed.com> >>> wrote: >>> >>>> Reuben, >>>> >>>> I would check the bow eye. The wood backing block usually rots and the >>>> eye >>>> loosens up. Sometimes just lifting the boat using the bow eye will cause >>>> the eye to loosen as the wood compresses. >>>> >>>> Also, you may want to re-bed the bow pulpit rail deck fittings, chocks, >>>> etc. >>>> >>>> Mike >>>> s/v Wind Lass ('91) >>>> Nissequogue River, NY >>>> I’d rather be sailing :~) >>>> >>>> -----Original Message----- >>>> From: Rhodes22-list <rhodes22-list-bounces at rhodes22.org> On Behalf Of >>>> Reuben Mezrich >>>> Sent: Monday, March 1, 2021 4:08 PM >>>> To: The Rhodes 22 Email List <rhodes22-list at rhodes22.org> >>>> Subject: [Rhodes22-list] Leak at the bow....where to look first >>>> >>>> As I mentioned a week or two ago, I installed a Marinco 3" Day/night >>>> solar >>>> vent at the bow, using the hole already in place for the anchor locker. >>>> It >>>> installed easily, seemed to work fine but a few days later we had a >>>> heavy >>>> rain and the next day the forward tips of the forward cabin cushions >>>> were >>>> wet. I removed the vent, replaced the deck plate, installed a new gasket >>>> under the deck plate, applied a generous amount of RTV silicone to both >>>> sides of the gasket and reinstalled the solar vent. The next day >>>> (yesterday >>>> actually) I used a hose to rain water on the forward deck, aiming at the >>>> solar vent for about 6 minutes and when I checked below everything was >>>> dry. >>>> I checked again in an hour and it was still dry. >>>> This morning there was about a cup of water, maybe two cups of water at >>>> the bow. There was no water in the tray that serves as the anchor locker >>>> and which is directly under the solar vent. The vent itself was dry as >>>> was >>>> the ceiling around the vent. The walls were also dry. I dried the water >>>> with a towel and a few hours later a small amount of water seemed to be >>>> seeping under a triangular piece of wood at the very bow of the boat >>>> (see >>>> attached photo). I haven't removed that piece of wood yet but I'm pretty >>>> sure I'll find the bolts from the chain plate at the bow for the jib >>>> stay. >>>> My feeling now is that the solar vent was never the source of the leak >>>> but >>>> I've had a small leak for a while but never noticed because I never had >>>> a >>>> reason to go up to the very front of the forward cabin. As it turns out >>>> the >>>> bottom of the cushions, which are rubberized are stained, giving >>>> evidence >>>> that the leak is likely long standing. >>>> Those bolts would be my best guess as the source of the leak but I'd >>>> look >>>> forward to suggestions as to where else I might look. >>>> >>>> Its always something >>>> >>>> --Reuben >>>> >>>> >>>> Reuben Mezrich >>>> Pelican Cove in Sarasota >>>> Cell: 410-499-8922 >>>> >>>>> >>>>> >>>> -------------- next part -------------- >>>> A non-text attachment was scrubbed... >>>> Name: Screen Shot 2021-03-01 at 4.02.36 PM.png >>>> Type: image/png >>>> Size: 1826288 bytes >>>> Desc: not available >>>> URL: < >>>> >> http://rhodes22.org/pipermail/rhodes22-list/attachments/20210301/6a1cf705/attachment.png
To use your email application to send a messsage to the webmaster rather than this form, .
Your post is being sent... 