The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

Goodness



mooring

2021-03-11; 11:45:52 EST

Member Since

2012-01-04

Posts: 260

I tie my bow eye to the mooring with a large stainless marine caribiner.   I feel it is less likely to saw through with wave action like chocks can.  I take a dinghy out to my mooring though and use it to clip on to the eye because i cant reach it easily from the deck.
So as i return to the mooring i pick up the painter with a boat hook and tie it to the deck bow cleat.  Then put everything away and do the switch as i am leaving in the dinghy. I have used the dingy painter to tie to both mooring and boat if the wind was up while doing the switch.

Mooring is a #150 mushroom jetted 5’ deep into the sand with a #60 section of 6’ ship chain attached to the 25’ galvanized mooring chain attached to the White/blue stripe mooring ball.  My painter is 25’ 3/4 inch nylon anchor rope with a small float and a 10’ floating poly line for pickup.  I do have a good bit of swing but its an empty mooring field that ranges from 8-12’ deep.

Bob (Palatka)

See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting