< prior
Back to Month
Go to Thread
2021-03-26; 10:16:06 EDT
Member Since
2008-12-25
Posts: 1035
Graham, Maybe you can get in earlier, cheaper model from Stan. I have one that works fine, just slower. Rick LangeSee the original archive post
On Fri, Mar 26, 2021, 10:11 AM Graham Stewart <gstewart8 at cogeco.ca> wrote: > I have been interested in the traveler discussion. My boat (1976) didn't > have a traveler when I got it and the mainsheet was simply attached to the > table base in the cockpit. My backstays are not equipped to install a > traveler and replacing the stays with new ones seemed cost prohibitive to > me. Initially I installed a traveler between the lazerette and the cockpit > seats. That worked well enough but made movement around the cockpit > awkward. > > My latest version was to mount the traveler track to a 1" stainless steel > tube and fasten that to my stern rail where it would seem to work in a > manner similar to those attached to the back stays. The rail does not flex > like the backstays would but I don't know if that is a good thing or not. > While this system seems very strong to me I am no engineer or otherwise > qualified to know. > > For those who are reluctant to pay the cost of both the backstay > replacement plus the cost of the new traveler this arrangement might be > worth considering. > > I like that the traveler being close to the stern rail means I don't have > an additional barrier to reaching over the stern rail to lift the motor and > that it is out of the way when sailing. I don't like the fact the it is > awkward to reach the lee traveler line. Any thought on improvements or > worries about this installation would be welcome. > > Graham Stewart > Agile, Rodes 22, 1976 > Kingston Ontario > > > > > > > > -----Original Message----- > From: Rhodes22-list [mailto:rhodes22-list-bounces at rhodes22.org] On Behalf > Of Curtis Ruck via Rhodes22-list > Sent: Thursday, March 25, 2021 9:45 PM > To: The Rhodes 22 Email List > Subject: Re: [Rhodes22-list] [Rhodes22e-list] New Traveler Modifications > > Hmm, i'll jump in and throw my two cents in, with my 1976 R22. > > When i'm racing in gusty 15+ knots... i am typically sitting on the side > rails above the seat, with one hand on the tiller extension and my other > fully gloved hand is holding the mainsheet uncleated, and i use that hand > to either let slip the mainsheet in a strong gust, or i give and take a > little with my hand holding the mainsheet from flying loose. I have a > harken 3:1 windward sheeting traveler rail mounted on the back stays. I > try to get the mainsheet as flat as possible. I would never use my > traveler to try controlling the main for gusting, holding the uncleated > mainsheet just feels natural, a little give, a little take, lets me feel > like i'm riding with the wind, and it allows instant response. Though on > long races my arms feel it. > > BTW, my traveler setup in the picture. I mounted the harken traveler rail > on a 1" OD Fiberglass tube with stainless 316 mounts on each end that the > backstays run through. Mounts are attached to the backstay with a small > stainless tube slightly larger than the backstay diameter to reduce the > friction wear on the backstays. I love the setup, but sometimes wish I had > a fixed traveler rail that wasn't floating. > > [image: image.png] > > -- > Curtis > > > On Thu, Mar 25, 2021 at 8:38 PM Shawn Boles <shawn.sustain at gmail.com> > wrote: > > > Oh boy, a match race! Much more enjoyable than the obscene, but > > fascinating, America's Cup races I just watched. > > > > Cheers, > > Shawn s/v Sweet Baboo (1986/2010) > > > > On Thu, Mar 25, 2021, 1:49 PM Rick Lange <sloopblueheron at gmail.com> > wrote: > > > > > Roger, > > > > > > I learned to sail and race by taking a college physical education class > > > over 50 years ago. I've raced dinghies through keel boats, including > the > > > R22, and as skipper, have a few blue flags to show for it. > > > > > > I accept your challenge to match race R22's with the IMF and diamond > > board. > > > > > > I challenge you to produce the videos you said are so common > > demonstrating > > > using the traveller on small sloops to dump wind during gusts > > > that overpower while close hauled. > > > > > > Regards, > > > > > > Rick Lange > > > > > > > > > On Thu, Mar 25, 2021 at 2:44 PM ROGER PIHLAJA <roger_pihlaja at msn.com> > > > wrote: > > > > > > > Rick, > > > > > > > > We were having a discussion of mainsail trim and traveler use in > heavy > > > air > > > > wherein the rig needs to be depowered in gusts and then quickly > brought > > > > back on line after the gust has passed. Mainsail shape for <= 10 > knots > > > is > > > > considered light air and is a different subject. As you noted, the > > > optimum > > > > light air mainsail shape is achieved with a different traveler car > > > position > > > > and mainsheet tension vs heavy air. In light air, it is also much > less > > > > likely the rig will need to be depowered as per the original > > discussion. > > > > > > > > It is beyond the scope of my job description to give tutorials on > sail > > > > trim in all possible conditions. I suggest you take a class or go > > racing. > > > > > > > > Stan, > > > > > > > > I give up! I’ve tried to explain the merits of your GBI 29 Traveler > to > > > > the best of my ability. But, it’s not working. If you want to jump > > into > > > > this discussion, go ahead. But, I’m done. > > > > > > > > Roger Pihlaja > > > > S/V Dynamic Equilibrium > > > > > > > > > > > > > > > > > > -------------- next part -------------- > A non-text attachment was scrubbed... > Name: image.png > Type: image/png > Size: 3456191 bytes > Desc: not available > URL: < > http://rhodes22.org/pipermail/rhodes22-list/attachments/20210325/763bc9ee/attachment.png > > > -------------- next part -------------- > A non-text attachment was scrubbed... > Name: New traveller.jpg > Type: image/jpeg > Size: 128837 bytes > Desc: not available > URL: < > http://rhodes22.org/pipermail/rhodes22-list/attachments/20210326/74da184f/attachment.jpg > > > -------------- next part -------------- > A non-text attachment was scrubbed... > Name: Taveller end hardware.jpg > Type: image/jpeg > Size: 106100 bytes > Desc: not available > URL: < > http://rhodes22.org/pipermail/rhodes22-list/attachments/20210326/74da184f/attachment-0001.jpg > > >
To use your email application to send a messsage to the webmaster rather than this form, .
Your post is being sent... 