The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

ROGER PIHLAJA



[Rhodes22e-list] New Traveler Modifications - another alternative

2021-03-26; 12:50:03 EDT

Member Since

2002-08-01

Posts: 1438

Michael,

OK, last response for me on this topic

I assume you are pushing/pulling on the correct part of the control line tackle, the part with the mechanical advantage?

You use the clam cleat to set the tension in the control line.  Less tension = easier movement but also a lower mainsheet force threshold before the traveler car starts to slide along the bar to leeward.  The tension must be set high enough; that, the traveler car does not move along the bar under “normal” mainsheet force.  Your tolerance for risk will determine how much you go beyond that minimum.  It’s something that is best determined out on the water.  If the traveler car is slipping under conditions you think are normal; then, increase the control line tension.  We have our control line tension set pretty high.  Once you have set the control line tension, cleat off the line and leave it alone.  You normally only push/pull on the control line to move the traveler.

If you find the traveler car is hard to adjust even with mechanical advantage; then, I would take a look inside the traveler car and turning blocks to see if there’s something stuck/broken/crudded up in there.  Stan, correct me if I’m wrong; but, I don’t think it needs to be lubricated.  I think it helps to keep the traveler bar bright and shiny.  But, this might be just my preferences as a chemical engineer.  Chemical engineers are irresistibly drawn to bright, shiny, polished alloy steel equipment!  I sail on fresh water and my traveler hasn’t needed any attention, other than external cleaning, for 3 years.  If you sail on salt water, the traveler might need more maintenance, just like all the other running rigging on your boat.

If all this fails to make your GBI 29 Traveler move more easily; then, I’m stuck and defer to Stan.  I suppose it’s possible there could be a manufacturing defect.

Roger Pihlaja
S/V Dynamic Equilibrium

Sent from Mail<https://go.microsoft.com/fwlink/?LinkId=550986> for Windows 10

From: Michael McKay<mailto:mm.bizlist1 at gmail.com>
Sent: Friday, March 26, 2021 11:56 AM
To: The Rhodes 22 Email List<mailto:rhodes22-list at rhodes22.org>
Subject: Re: [Rhodes22-list] [Rhodes22e-list] New Traveler Modifications - another alternative

One last group of questions before we change the topic—I am new to my R22,
but I find my traveler very “stiff” and fairly hard to adjust without
considerable physical effort.  Is that normal or does it need some
lubrication?  How much tension should be in the traveler line?

Thank you for the very informative discussion.

See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting