The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

ROGER PIHLAJA



Crane question

2021-03-31; 09:25:38 EDT

Member Since

2002-08-01

Posts: 1438

Hi Allyn,

OK, I’m going to put on my engineer’s hat and do a safe load calculation for you.

Assumptions:

  1.  Model the tube as if we were buckling a theoretical column with the bottom end fixed and the top end free to move out of column
  2.  The column can buckle in any direction
  3.  D = 2.00 inch, t = 0.125 inch, L = 6.00 feet = 72.0 inch, [Pi] = 3.14159
  4.  The MOC is 6061-T6 Al Alloy     [Modulus of Elasticity] = E = 10000 ksi = 10000000 psi
  5.  [Safety Factor] = 3.0
  6.  [Moment Of Inertia] For A Tube = Ix = Iy = ([Pi] / 64) * (([D] ^ 4 – ([D] – (2 * t) ^ 4)) = 0.3250 inch ^ 4
  7.  Mast is moved slowly, so dynamic loads don’t need to be considered

With all these assumptions, the [Critical Axial Compressive Load] = [Pcr] = [Pi] ^ 2 * E * I / (4 * (L ^ 2)) = 1547 lbs

[Psafe] = [Pcr] / [Safety Factor] = 516 lbs in compression

You would need to do a statics calculation to determine the worst case compressive load on the column.  I don’t know your gin pole geometry, so I don’t have enough information to do that calculation.  My guess is, this is probably OK; but, its close enough that, I would do the calculation before I tried it.  Also, note that this is assuming failure by buckling under a pure compressive load.  If the aluminum tube moves out of column even a little; then, things will start to go crocked in a hurry!  I would want to see some sort of guy wires or a sacrificial assistant to hold the tube in column.

Hope this helps, good luck!

Roger Pihlaja
S/V Dynamic Equilibrium

From: Todd Tavares<mailto:tavares0947 at gmail.com>
Sent: Tuesday, March 30, 2021 10:08 AM
To: The Rhodes 22 Email List<mailto:rhodes22-list at rhodes22.org>
Subject: Re: [Rhodes22-list] Crane question

Allyn,

The .125 wall thickness aluminum tubes should be adequate if the diameter
is large enough > 1.5 or so.
Raising from the stern raised cradle using the GB mast raising system pole
is much easier and less risky than raising from the bow using the boom as
the gin pole.
There are plenty of pictures of the GB mast raising system on the web and
this list if you have the skill and desire to make a clone for yourself.
The GB system uses a winch with friction brake, mounted to the top of the
capitol mounted gin/crane pole. I use the trailer winch.
I can post some pics if I can dig them up.

Todd T.


See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting