Yes, I can see how I could have worded it better. You want the stopper "
arm" pushed all the way toward the tow vehicle .
Jerry Lowe
Just to clarify, when you say the bow stopper has to be all the way back
> you mean it should be retracted towards the front of the trailer—is that
> correct?
>> Michael McKay
>> Sent from my iPhone
>>> On Apr 30, 2021, at 6:41 AM, Mitch Mitchell <mitchpadl at gmail.com> wrote:
>>>> Makes sense. Thanks!
>>>>>>> On Fri, Apr 30, 2021 at 2:16 AM <cjlowe at sssnet.com> wrote:
>>>>>> Mitch,
>>> The bow stopper has to be all the way back so the bow eye doesn't hit
>>> the stopper when pulling out of the water. As you start to pull the
>>> trailer out of water, the boat is resting on the tip of forward end of
>>> the bunks and the aft end of the boat floats a foot or more above the
>>> back end of bunks. As the boat comes out, it rocks back and the bow of
>>> the boat raises about a foot, if you don't have the stop all the way
>>> back, you will rip off the bow eye pad, or worse.
>>> I like to have the bow eye pad about two inches forward of the bow for
>>> travel. The boat will rock almost that much in transit and there is no
>>> sense in beating up the bow by putting them tight together.
>>>>>> Jerry Lowe
>>>>>>>>>>>>>>> If that’s the case what would be the purpose of an adjustable bow
>>>> stopper?
>>>>>>>> Sent from my iPhone
>>>>>>>>> On Apr 28, 2021, at 10:50 PM, Peter Nyberg <peter at sunnybeeches.com>
>>>>> wrote:
>>>>>>>>>> I’ll disagree a bit here. I never move my ‘bow bumper’.
>>>>> I’ll put my bow as close to it as I can manage while the boat is
>>>>> still
>>>>> in the water. As Charles said, when the boat and trailer are pulled
>>>>> out
>>>>> of the water, the space between the ‘bow bumper’ and the boat
>>>>> will
>>>>> increase. This is inevitable, and not necessarily a problem. Moving
>>>>> the ‘bow bumper’ closer to the boat at this point just increases
>>>>> the
>>>>> likelihood of damage to the boat in transit.
>>>>>>>>>> Peter Nyberg
>>>>> Coventry, CT
>>>>> s/v Silverheels (1988/2016)
>>>>>>>>>>> On Apr 28, 2021, at 10:29 PM, Charles Nieman
>>>>>> <blue66corvette at hotmail.com> wrote:
>>>>>>>>>>>> Thomas
>>>>>> You float the boat, slide the bow bumper as far forward as possible,
>>>>>> tighten the boat as far to the front as possible. When you drive out
>>>>>> of
>>>>>> the water, the boat will shift to the stern, so the key is to keep
>>>>>> it
>>>>>> as close to the front as possible. After you get it out of the
>>>>>> water,
>>>>>> then you slide the bow bumper back to the boat to reduce bounce.
>>>>>> It’s
>>>>>> tricky, and I’ve had to retry a few times but it can be done.
>>>>>>>>>>>> Sent from my iPhone
>>>>>>>>>>>> Charles
>>>>>>>>>>>>>>>>>>>>>>>>>
×
Message to Webmaster:
To use your email application to send a messsage to the webmaster rather than this form,
.