2021-05-02; 00:28:35 EDT
Member Since
2021-04-27
Posts: 9
Hello Everyone, I’m a new owner of a 1988 Rhodes 22, and I’m in the process of assessing the condition and identifying requirements for launching. The boat has been sitting for about 8 years – It was shrink wrapped and appears to be in descent condition. The boat is on a trailer, and my centerboard is currently retracted. From the cockpit, there is a line in front of the cabin entrance that I’m assuming raises and lowers the board. I’m unable to verify this because it appears that the centerboard is being obstructed by one of the trailer rollers. The line that controls the centerboard looks kind of old, but I’m not sure whether I should dismantle the cabin to replace it – My primary concern is the cap seal and gasket. Are these common sources for leaks ? Another question if someone has time - In the cockpit, it appears that the table mount has been replaced with a round access hatch. When I open that, I just see foam. Is that normal ? Behind the access panel (old table mount), in the rear of the cockpit is a drain which has a hose attached that runs out the bottom of the boat. I just want confirmation that’s normal and that I’m not missing any parts ? I would think I would want a screen or something covering that to prevent clogs. I’ve got a ton of questions - I’ve downloaded every Rhodes related PDF/Document that I can find on the Internet. Does anyone know if there is a schematic available for the boat ? or a full parts list ? Any information, suggestions would be most welcomed. Attaching a few pics Thank you in advance. IMG_0913.jpg IMG_0896.jpg IMG_0915.jpg IMG_0897.jpg -- Sent from: http://rhodes-22.1065344.n5.nabble.com/See the original archive post