2021-05-02; 13:02:53 EDT
Member Since
2005-04-29
Posts: 814
Welcome to the list and Rhodes ownership. Your boat looks great. Problems with the centerboard leakage can develop but I would not start taking the cap off unless you have actually identified problems. There is a very good likelihood that everything is fine and removing the cap is a PITA that you want to avoid until it is clearly necessary. Put the boat in the water and check the bilge for any leaks. If there are no leaks just go sailing. The weight of the centerboard on the tether is only about 45 lbs so unless the line is seriously worn it is very unlikely that it will break in normal use. The roller on the trailer is intended to hold the centerboard in place. When on the trailer I like to tension the painter a bit to stabilize the centerboard but not lift it off the roller. The boat is built with positive flotation under the V-birth and under the cockpit sole. It is comforting to have a boat that won't sink. The inspection cover in the cockpit was added by a previous owner for reasons only he would know. He put the inspection port where there was a mounting bracket for the table pedestal. It would be identical to the one in the cabin floor. The intention was to allow you to use the table in the cockpit when not sailing. I found that I didn't use mine and the floor mount was a nuisance at times so when I rebuilt my boat I filled the screw holes and left it off. Now that the section of the floor has been removed, you would have to rebuild the sole before one could be installed and I doubt that would be worth the trouble. Make sure the inspection port is water tight. These things come in two types, inspection ports and deck plates, which look identical in pictures. As the names imply deck plates are much stronger, form a better seal are intended for situations like yours where there is an opening in the deck. An inspection port is light duty and intended for interior or vertical surfaces. It is also a lot cheaper so it would not be surprising to see an inspection ports where a deck plates would be more appropriate. If yours is just an inspection plate I would keep an eye on it and if there is any indication of leaking replace it with a deck plate. The drain in the cockpit floor allows water that might come into the cockpit to drain quickly for obvious reasons. A screen would only collect debris and slow the drain. Leave it open and unobstructed. You might also check the other drains to make sure they are clear especially if they are only 1/2 inch drains. Don't worry about asking questions. It is much better to ask a stupid question than to make a stupid mistake. We have all done that on multiple occasions and know that can be costly. Graham Stewart Agile, Rodes 22, 1976 Kingston OntarioSee the original archive post