< prior
Back to Month
Go to Thread
2021-05-03; 11:30:29 EDT
Member Since
2002-09-10
Posts: 976
I see Rogers reply in black to the quoted email text in red... Todd T. tavares0947 at gmail.comSee the original archive post
On Mon, May 3, 2021, 10:01 AM ROGER PIHLAJA <roger_pihlaja at msn.com> wrote: > Rob, > > It looks like the server stripped out my bold red text replies and > substituted plain text. My replies are mixed in with the original post; > but, not highlighted in any way. It certainly makes it hard to read. I > won’t try that again! It’s kind of a shame because I’ve found responding > to multiple questions in a different color in the same document is very > easy and effective. But, apparently our server doesn’t support it. > > Roger Pihlaja > S/V Dynamic Equilibrium > > Sent from my iPhone > > > On May 3, 2021, at 9:26 AM, Lowe, Rob <rlowe at vt.edu> wrote: > > > > ?Roger, > > I'm not seeing your replies to Jim's post?? - Rob > > > > ________________________________ > > From: Rhodes22-list <rhodes22-list-bounces at rhodes22.org> on behalf of > ROGER PIHLAJA <roger_pihlaja at msn.com> > > Sent: Sunday, May 2, 2021 8:54 AM > > To: The Rhodes 22 Email List <rhodes22-list at rhodes22.org> > > Subject: Re: [Rhodes22-list] Centerboard Question > > > > Hi Jim, > > > > I added my replies in red to your original post. > > > > Roger Pihlaja > > S/V Dynamic Equilibrium > > > > Sent from Mail<https://go.microsoft.com/fwlink/?LinkId=550986> for > Windows 10 > > > > From: JimIggy<mailto:zooba72 at hotmail.com> > > Sent: Sunday, May 2, 2021 12:28 AM > > To: rhodes22-list at rhodes22.org<mailto:rhodes22-list at rhodes22.org> > > Subject: [Rhodes22-list] Centerboard Question > > > > Hello Everyone, > > > > I’m a new owner of a 1988 Rhodes 22, and I’m in the process of assessing > the > > condition and identifying requirements for launching. The boat has been > > sitting for about 8 years – It was shrink wrapped and appears to be in > > descent condition. The boat is on a trailer, and my centerboard is > > currently retracted. From the cockpit, there is a line in front of the > > cabin entrance that I’m assuming raises and lowers the board. I’m > unable > > to verify this because it appears that the centerboard is being > obstructed > > by one of the trailer rollers. Yes, the line is called the “centerboard > pennant”. > > The line that controls the centerboard > > looks kind of old, but I’m not sure whether I should dismantle the cabin > to > > replace it – My primary concern is the cap seal and gasket. Are these > > common sources for leaks ? The centerboard hangs down ~3 ft below the > keel > > when it is lowered. If the trailer didn’t hold it up, it would drag on > the road! > > In addition, when retrieving the boat onto the trailer, it is very > helpful to leave > > the centerboard down about a foot. The centerboard will engage with the > > trailer keel rollers, thus helping to center the boat on the trailer. > The trailer > > rollers will cause the centerboard to retract at the appropriate point > in the > > retrieval operation as the boat comes up onto the trailer. It’s very > slick! > > The centerboard pennant runs in a block on the trailing edge of the > center- > > board. The run is very fair and the pennant is protected from the > elements by the > > centerboard well. Inspect the part of the pennant that you can see. As > long > > as it’s not fraying, it’s very unlikely the unseen part of the pennant > has an issue. > > I would try launching the boat and lowering the centerboard to see > whether it > > operates smoothly before I just replaced it. When the centerboard is > lowered, > > you should dive under the boat and check the side-to-side play in the > centerboard. > > Excess side-to-side play indicates a worn centerboard pivot. Fixing > this issue will > > require removing the centerboard. Replacing the pennant or removing the > center- > > board involves removing about 24 screws on the cap to gain access to the > > centerboard well. There should be a gasket; but, on some boats, the cap > may be > > sealed with silicone RTV. Whether your boat has a gasket or silicone > RTV, it is very > > important you get the cap sealed when you put it back together. This > cap is below > > the waterline and you will get a leak into the bilge if it’s not > properly sealed. It’s > > enough of a royal PITA; that, I wouldn’t mess with it unless I had more > evidence. > > > > Another question if someone has time - In the cockpit, it appears that > the > > table mount has been replaced with a round access hatch. When I open > that, > > I just see foam. Is that normal ? Yes, there is floatation foam > under the cockpit > > and that inspection port is located where there should be a table mount. > > Behind the access panel (old table > > mount), in the rear of the cockpit is a drain which has a hose attached > that > > runs out the bottom of the boat. I just want confirmation that’s normal > and > > that I’m not missing any parts ? I would think I would want a screen or > > something covering that to prevent clogs. NO! You don’t want a screen > or anything > > else that might get clogged and slow down the cockpit drain. > > > > I’ve got a ton of questions - I’ve downloaded every Rhodes related > > PDF/Document that I can find on the Internet. Does anyone know if > there is > > a schematic available for the boat ? or a full parts list ? Any > > information, suggestions would be most welcomed. Attaching a few pics > > > > Thank you in advance. > > > > > > <http://rhodes-22.1065344.n5.nabble.com/file/t1015/IMG_0913.jpg> > > <http://rhodes-22.1065344.n5.nabble.com/file/t1015/IMG_0896.jpg> > > <http://rhodes-22.1065344.n5.nabble.com/file/t1015/IMG_0915.jpg> > > <http://rhodes-22.1065344.n5.nabble.com/file/t1015/IMG_0897.jpg> > > > > > > > > > > -- > > Sent from: http://rhodes-22.1065344.n5.nabble.com/ > > >
To use your email application to send a messsage to the webmaster rather than this form, .
Your post is being sent... 