The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

ROGER PIHLAJA



Axle location

2021-05-21; 08:03:28 EDT

Member Since

2002-08-01

Posts: 1438

Graham,

You will need a bathroom scale that reads up to 350 lbs and 2 hydraulic bottle jacks.  First load up the boat as you will have it for trailering it down the road.  In my case, that includes a full tank of fuel, empty porta-potti, full water tank, and of course, the outboard mounted on the transom.  I assume you have a tongue jack?  If not, you will need a jack stand or something to support the end of the tongue on top of the scale.  Start by putting the tongue jack on top of the scale and get a tongue weight measurement.  The rule of thumb for tongue weight is about 10% of the gross trailer weight in order to have stability.  Figure your boat and single axle trailer weighs about 3100 lbs.  So, you need about 310 lbs of tongue weight.  Now, jack the trailer frame up from the same spot on both sides.  I would start immediately behind the tires.  Get the trailer’s frame at approximately the same level as when it was supported by the tires.  Note that you will probably have to remove the tires to get it low enough.  Now, measure the tongue weight as before.  It should be greater than before.  Keep moving the jack points aft until you find a spot on the frame that gives you about 310 lbs of tongue weight.  That’s where your single axle needs to be moved to.

By the way, your R-22 is the same year as mine.  The early R-22’s had porta-potti’s, not marine toilets and holding tanks.  Where is your water tank located?

Roger Pihlaja
S/V Dynamic Equilibrium



Sent from Mail<https://go.microsoft.com/fwlink/?LinkId=550986> for Windows 10

From: Graham Stewart<mailto:gstewart8 at cogeco.ca>
Sent: Thursday, May 20, 2021 9:59 PM
To: 'The Rhodes 22 Email List'<mailto:rhodes22-list at rhodes22.org>
Subject: Re: [Rhodes22-list] Axle location

Thanks to all for their suggestions. It seems that the best solution for me would be to have the axle moved back. I don't trailer enough to justify the second axle and the other option to add weight to the tongue seem to me to be a workaround rather than a fix and moving the boat forward is both very difficult and damaging to the hull. The area immediately aft of the V-birth hold my holding tank and battery, not my water tank,  so obviously I am not going to keep my holding tank full permanently.

The big question for me now is to determine exactly how far aft I will have the axle moved. If anyone can suggest how I might determine that distance I would be grateful to hear your suggestions.

Graham Stewart
Agile, Rodes 22, 1976
Kingston Ontario






See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting