2021-05-29; 06:44:50 EDT
Member Since
2002-08-01
Posts: 1438
Allyn, I went back and reread your post. When you say the top of the forestay snapped right where the threads start, that sounds exactly like what happened to Peter’s S/V Silverheels. Peter has posted an excellent U-Tube video of the issue and his fix. Unfortunately, you will have to replace your forestay just like he did. I’ve attached a copy of my post to Peter: Peter, S/V Silver Heels experienced scenario #1 from my previous post. If Allyn’s boat experienced the same issue; then, we may have a problem area. We might want to warn the whole Rhodes list to inspect the toggle joints on the top of their forestays. From your U-Tube video, your failure looked like a chloride stress cracking fatigue failure. Such failures are common with 300 series stainless steel alloys in a salt water environment. They can be early detected by dye penetrant, magnaflux, or ultrasonic testing. Dye penetrant would be the easiest for the average boat owner. All boats that sail on salt water would be subject to this issue. Roger Pihlaja S/V Dynamic Equilibrium Peter and Allyn, what year are your boats? You can tell from the W/C registration number on the transom. Do you know if the forestays have ever been replaced? I’m wondering if we have an issue with chloride stress cracking fatigue due to hours of use or perhaps a defective batch of swaged terminals? If your boats were made around the same time, we could have a defective batch of parts. In any case, it certainly wouldn’t hurt for everybody to take a close look at the toggle joint at the top of your forestay. A dye penetrant test would be best; but, at least look closely with a magnifying glass for tiny cracks &/or rusty reddish brown discoloration on or near the threads. If you see anything like this, I recommend you immediately replace at least the threaded component of the toggle joint, assuming you can get it apart. If you can’t get it apart; then, replace your whole forestay. Chloride stress cracking fatigue is one of those failure mechanisms that can proceed very rapidly from hardly anything visible to total failure. The failure will likely happen when your rig is heavily stressed – i.e. just when you don’t need problems! Roger Pihlaja S/V Dynamic Equilibrium Sent from Mail<https://go.microsoft.com/fwlink/?LinkId=550986> for Windows 10 From: Allyn Baskerville<mailto:allynb at adsne.com> Sent: Friday, May 28, 2021 7:47 PM To: The Rhodes 22 Email List<mailto:rhodes22-list at rhodes22.org> Subject: Re: [Rhodes22-list] CDI Furler Wire Halyard Snapped - What's at the top? Thanks, Roger. I'm dropping the mast in the morning and will let you know.See the original archive post