The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

ROGER PIHLAJA



CDI Furler Wire Halyard Snapped - What's at the top?

2021-06-04; 07:00:37 EDT

Member Since

2002-08-01

Posts: 1438

Allyn,

Remind me again, does your R-22 have IMF?  S/V Dynamic Equilibrium has a conventional mainsail.  The IMF mainsail does not have battens and less roach vs. a conventional mainsail.  A mainsail is not a triangle.  If you were to draw a line from the head to the clew, you would find a conventional mainsail has some sail area aft of this line and an IMF mainsail has almost none.  In other words, an IMF mainsail is closer to a pure triangle vs. a conventional mainsail.  This “extra” sail area is called roach.  IMF mainsails don’t have the battens which are necessary to support the extra sail area in the roach, so they can’t have much roach.  All else being equal, this lack of roach moves the center of effort (CE) of an IMF mainsail slightly forward vs. a conventional mainsail.  This would mean the mast needs to be tilted slightly more aft on an IMF rig to balance the weather helm/lee helm balance.  So, if you have IMF, your longer forestay measurement makes sense.  Believe your tape measure, especially if you’ve measured it several times and gotten the same result.  The real question is, do you like your boat’s present weather helm/lee hem balance?  If you would like less weather helm, shorten the forestay.  More weather helm, lengthen the forestay.  Shortening the forestay by 3.5 inches would significantly reduce your weather helm.

You probably have more backstay adjustment than you think.  Remember, you also have the double backstay adjuster rigging, which has a range of at least 12 inches.  As long as the slack double backstays are long enough to step the mast and hook up the forestay pin to the bow chain plate, the double backstay adjuster will take up whatever slack remains.  Another thing to consider – How long is your CDI furling tube?  If you shortened the forestay by 3.5 inches, would the furling tube be too long?  You might consider shortening the forestay until the upper end of the furling tube just clears the toggle joint at the masthead.  That would be the best you can do to reduce weather helm without modifying your furling tube.

Roger Pihlaja
S/V Dynamic Equilibrium

Sent from Mail<https://go.microsoft.com/fwlink/?LinkId=550986> for Windows 10

From: Allyn Baskerville<mailto:allynb at adsne.com>
Sent: Thursday, June 3, 2021 11:02 PM
To: The Rhodes 22 Email List<mailto:rhodes22-list at rhodes22.org>
Subject: Re: [Rhodes22-list] CDI Furler Wire Halyard Snapped - What's at the top?

Thanks for the info. I've not been on another Rhodes, but I've spent considerable time on a Capri 22. Based on that, I'd say my boat has excessive weather helm, and I really appreciate the info you provided.

I've not made any adjustments to the forestay assembly, and the only thing I'm guessing on is adding 3/4" for the piece of the toggle joint that broke off to the point where the pin goes through. I measured this 6 times, and 3 times I came up with about the same measurement: 28' 1-3/4" +/- 1/8" center to center. Just to clarify, the distance from the center of the pin that goes through the chain plate to where the toggle fork broke is 28' 1", then I added 3/4" for where the piece broke off to where I think the pin would be. The forestay wire is 27' 6-1/4" (taken to the outer edge of the swage crimp). I really think I'd run out of adjustment on the backstays if the forestay was about 3.5" shorter. I'll go back out to my boat, but I'd be surprised if there was more than 1.5-2" of adjustment available on the backstays.

You also mentioned chloride stress cracking fatigue failure. The boat was a one owner and came from Wisconsin and had a Wisconsin title, and I don't know if it was ever sailed in salt water. The hull was coated in mineral deposits, which I continue to work on. But then our lake water isn't much better.

I worked on this email far to long, but I'm hoping it's relatively clear to understand.

See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting