The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

joedempsey



Pintle Screw size and availability

2021-06-14; 14:29:02 EDT

Member Since

2016-12-14

Posts: 257

Matt,
I just "re-built" my rudder this past off season. The bolt that you are talking about is shorter than the remaining bolts. They are all the same diameter, I think 3/8". There should be one on the opposite side.  Remove it and measure for length. These two are shorter so they don't interfere with hauling up the rudder and they do not have lock nuts like all of the others. Be sure to replace with 316 Stainless steel. You can get them from Fastenal or McMaster and Carr. If you're close to a West Marine, they can probably match what you need, but be sure it's either 304 or 316 grade. Take one to your local hardware store and check for fit in their guage that they have in the nuts and bolts department so you'll have the correct thread pattern. Problem is they don't have marine grade hardware and their stainless will rust out in a year.

In the photos, the inboard (short) screws are removed. Note in the Rudder up photo the location of the outhaul line, which I had just replaced. That stainless rod had been dislocated (separate photo) and I had to do a repair to get it back in place. It's purpose is to provide a smooth surface for the line to slide on. Note the new Downhaul (red) line in each of the photos.

I've taken the opportunity to attatch two additional photos: "Rudder Down and not locked" and "Rudder Down and Locked". Note the relative position of the rudder in the "locked" position. This is attained by using the Rudder Down Haul line to pull the rudder as far down and forward as it will go and using the hand wheel to tighten the line to keep the rudder in place. This will take enormous pressure off of the strong weather helm.   It took me nearly four years to learn this when Stan answered the exact question you initially asked. I had reinstalled a long bolt where the two short ones should have gone that did not allow the rudder to extend much beyond the horizontal.

Hope this helps.

Rudder_Down_Position.jpg

Rudder_Up_1.jpg

Rudder_Pinion.jpg

IMG_20210513_1435462.jpg

Rudder_Mounted_in_UnLocked_Position.jpg

Rudder_Mounted_in_Locked_Position.jpg




-----
Joe Dempsey
s/v Respite
Rhodes 22 1989/2005
Deltaville,VA
--
Sent from: http://rhodes-22.1065344.n5.nabble.com/
See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting