The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

joedempsey



Pintle Screw size and availability

2021-06-14; 15:25:40 EDT

Member Since

2016-12-14

Posts: 257

Last year I was having difficulty raising and lowering the rudder and after hauling for the winter, inspected and found the rod as seen in the photo. It was held in place by two #6 or #8 1" or 1-1/4" screws. It's either  1/4" or 3/8" stainless rod (going from memory). Fortunately it had not been deep sixed and was hanging on by one of the screws. As you can see, the downhaul line had worked itself inside of the rod. I'm guessing it was intended to go around the rod. I never checked with Stan, but figured since without going around  the rod, it was pulling at an awkward angle and also pinching inside the rudder housing.  Looking back at the photo, I'm going to guess with the 3/8" size. You can order 316 ss rod from McMaster and Carr and cut to the length you need. Then bore holes on either side to match up with each side of the rudder housing. You should find holes already in the edges of the housing. They may need some repair. As I recall, the screws that held the rod in place seemed somewhat skimpy and I may have beefed them up, but don't remember. Obviously, thickness of the housing sides will dictate.



-----
Joe Dempsey
s/v Respite
Rhodes 22 1989/2005
Deltaville,VA
--
Sent from: http://rhodes-22.1065344.n5.nabble.com/
See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting