> On Jun 15, 2021, at 9:11 AM, Graham Stewart <gstewart8 at cogeco.ca> wrote:
>> ?Mark:
>> If it would be helpful, I can take some photos of my rudder and the arrangement with the screws.
>> Graham Stewart
> Agile, Rodes 22, 1976
> Kingston Ontario
>>>>>>>> -----Original Message-----
> From: Rhodes22-list [mailto:rhodes22-list-bounces at rhodes22.org] On Behalf Of Matt Wilson
> Sent: Monday, June 14, 2021 9:10 PM
> To: The Rhodes 22 Email List
> Subject: Re: [Rhodes22-list] Pintle Screw size and availability
>> Thanks everyone!! I greatly appreciate it!
>>> On Mon, Jun 14, 2021 at 8:02 PM Graham Stewart <gstewart8 at cogeco.ca> wrote:
>>>> Those are just very short flathead machine screws. There should be one on
>> each side. The head goes in from the inside and the locknut is what shows
>> on
>> the outside. Just get a stainless steel flat head machine screw that fits
>> the hole diameter, insert it from the inside. Fasten the locknut and cut
>> off
>> the extra.
>>>> Graham Stewart
>> Agile, Rodes 22, 1976
>> Kingston Ontario
>>>>>>>>>>>> -----Original Message-----
>> From: Rhodes22-list [mailto:rhodes22-list-bounces at rhodes22.org] On Behalf
>> Of
>> Hornblower
>> Sent: Monday, June 14, 2021 12:02 PM
>> To: rhodes22-list at rhodes22.org>> Subject: [Rhodes22-list] Pintle Screw size and availability
>>>> Hi everyone,
>>>> This is an amazingly helpful forum for a new Rhodes owner like me! I am
>> appreciating all the info and advice I read daily!
>>>> My boat came to me missing the portside lower pintle screw seen in the
>> picture. Can anyone tell me exactly what size it is and where I can get
>> another? Many thanks!
>> Matt
>>>> <http://rhodes-22.1065344.n5.nabble.com/file/t1016/IMG_3060.jpg>
>>>>>>>> --
>> Sent from: http://rhodes-22.1065344.n5.nabble.com/>>>>>
×
Message to Webmaster:
To use your email application to send a messsage to the webmaster rather than this form,
.