The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

Michael D. Weisner



Rudder repair

2021-06-24; 22:13:50 EDT

Member Since

2006-06-11

Posts: 1826

Thomas,

Take a look at these recent emails. I think that the exact issue was addressed:
http://www.rhodes22.org/pipermail/rhodes22-list/2021-June/088432.html

especially the later post by Graham Stewart:
http://www.rhodes22.org/pipermail/rhodes22-list/2021-June/088435.html
"Those are just very short flathead machine screws. There should be one on each side. The head goes in from the inside and the locknut is what shows on the outside. Just get a stainless steel flat head machine screw that fits the hole diameter, insert it from the inside. Fasten the locknut and cut off the extra. "

Mike
s/v Windlass ('91)
Nissequogue River, NY

See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting