The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

Jesse Shumaker



Unbolted track

2021-07-26; 11:28:16 EDT

Member Since

2019-06-04

Posts: 463

Just curious for those that have added backing plates in certain scenarios, what material have you used for this?

I've used steel sheet metal from Home Depot that I cut to size with an angle grinder and painted with Rustoleum primer and paint before installation.  I didn't find stainless steel sheet metal at the hardware store or home improvement stores.  I don't recall the gauge/thickness that I used.  I also used fender washers on top of the backing plates.  I've added backing plates for the bow cleat, two chocks that I installed towards the bow, a flip up midship cleat that I installed, as well as the through bolts for the anchor roller mount... so far so good.

Jesse Shumaker
S/V Zephyr

See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting