The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

ROGER PIHLAJA



Electric motor mount vibration

2021-08-31; 15:33:13 EDT

Member Since

2002-08-01

Posts: 1438

Jeff,

Fortunately, the throttle and shifter on my Honda 8hp Extra long shaft outboard are separate.  I’m using a Honda 9.9 hp remote control mounted on the port side gunnel.  The Honda remote control is a single lever shifter + throttle with a separate warm-up throttle lever.  If it’s necessary, I still have to operate the choke at the engine.  In the attached photo, you can see the single engine control lever sticking up above the port side gunnel.  The lever is inside of it’s blue UV protective sock.  Note how the throttle and shifter cables have a spiral bend in them.  This enables them to accommodate the vertical, side to side, and tilting motions of the motor mount and engine itself.  I can only tilt the motor up to the 2nd detent.  But, when the motor mount is fully raised, the 2nd tilt detent allows the lower unit to clear the water unless the port rail is in the water.  i.e. 99+ % of the time.  & remember, I have an extra long shaft engine.

You have to try having the engine remote controls in your left hand and the tiller in your right hand while you stand at the helm station to appreciate how nice this setup is for close quarter’s maneuvering and docking!  Your visibility is great, you have total engine throttle/engine shift/rudder steering control, you can pass dock lines to/from the boat, and you have access to the engine’s tiller if you need to do something fancy with the engine’s thrust.

The GBI motor mount puts the engine cowling at about the normal distance from the transom.  The Honda Engine/Remote Unit works just fine.  It’s hard to believe a Yamaha outboard couldn’t be made to work.  I would get a 2nd opinion.

Roger Pihlaja
S/V Dynamic Equilibrium

[cid:image003.jpg at 01D79E7D.8281BC40]



Sent from Mail<https://go.microsoft.com/fwlink/?LinkId=550986> for Windows

From: Jeff Smith Photo<mailto:jeffsmithphoto at gmail.com>
Sent: Tuesday, August 31, 2021 11:19 AM
To: rhodes22-list at rhodes22.org<mailto:rhodes22-list at rhodes22.org>
Subject: [Rhodes22-list] Electric motor mount vibration

The local Yamaha Dealer said they could not install remote controls on my Yamaha T8ELH because the motor was too close to the transom.  I'm still trying to get used to operating the throttle and shifter towards the end of my second season.
I would love to dismount the motor for long trailering in order to add to the tongue weight, but it is too much of a pain to do so.  I will carry my uninflated dinghy in the V berth (whether I end up inflating it or not) to increase tongue weight.
The noise of the motor annoyed me so I installed a double layer of KILMAT on the inside of the cowl, but an iPhone decibel meter didn't show much difference. I still have a bunch left, if someone wants to stop by or pay postage.
Whe WM transom matt has poor reviews, so I looked on McMaster-Carr and saw these choices.
<
https://www.mcmaster.com/rubber/rubber/multipurpose-neoprene-rubber-sheets-and-strips/

690C3CE697E44A38A943326774C58538.jpg
See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting