The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

Jesse Shumaker



Removing Mast from Boat

2021-09-10; 09:30:49 EDT

Member Since

2019-06-04

Posts: 463

Hi Jeff,

I remove my sails to store inside each winter and have adjusted the technique that I use over the last couple of years to make it a bit easier than my initial process.  I used to get a couple of friends to help me lift the whole mast + jib furler to the ground but that was a handful.

A couple of notes before getting into the steps:

   - My boat came with the mast raising system which is extremely helpful    - My boat has the GB in-house jib furler so I have to take the furler    down to remove the sail.  I know other jib furlers allow you to raise or    lower the sail while the mast is up.
   - The process I use doesn't remove the mast from the boat.

Here's my current approach for removing sails at the end of the season:

   - Lower the mast so the top rests on the mast crutch attached to the    stern rail
   - Unbolt the base of the mast and move the base of mast to bow pulpit    where it attaches
   - Unpin the forestay at the top of the mast so the furler and jib can be    removed separately and taken off the boat.  I set this on the ground and    will come back to it later.  I find it easier to handle the mast or    forestay separately rather than one big bundle.
   - Put a towel on the forepeak
   - Move the base of the mast so that it rests on the forepeak between the    bow pulpit attachments.  You can secure the base of the mast in this    position by tying it down.  At this point it is angled down and you can    slide out the furling unit with the mast still on the boat.  You'll need    quite a bit of room in front of the boat for this step.
   - Set the IMF furling unit on the ground.
   - Now that both furling units are on the ground, you can unfurl and    remove sails from this position and it doesn't stress the furling units.    - When you're done, you can slide the mainsail furling unit back in the    main and re-attach the jib furler.

For your purposes, you could just leave the furling unit attached and move that along with the mast.  I hope that helps. Good luck!

Jesse Shumaker
S/V Zephyr

See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting