The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

Lee Kuhn



Go Faster

2021-10-12; 17:55:14 EDT

Member Since

2020-10-30

Posts: 113

Allyn,

I don't race so take this for what it"s worth.  I also don't pay much attention to my speed if I'm going downwind although I do use wing-on-wing and a whisker pole and raise the centerboard.

I spend most of my time trying to go faster into the wind.  I look at the knot meter and then make small adjustments to try to gain speed.

Jeff"s advice about real meat is extremely important.  Only so much you can do if single handling.  Usually I start losing speed if heeling more than 25 degrees.  Always depends on the wind, point-of-sail, current, adjustments, wife's mood. etc.

Stan says if the wind is more than 28 knots it's time to unfurl the iron genny, but he's a better sailor than I.  If the wind is above 20 knots I can't make any headway.  If you search the archives under Lee and spreadsheet you'll find a post about sailing 3.5 knots at 40 degrees into the wind in heavy chop.  Wasn't much headsail in use.

I love the 175 Genoa but I don't believe it helps much with speed unless you're headed downwind with a whisker pole.  On a reach it takes 3 knots of wind to inflate the monster and starts to slow you down in a 5 knot wind. But she sure is pretty.  And how many boats do you see flying a headsail twice the size of their main?

Few will agree but the owner of J-Boats will confirm.  You can go a little faster into the wind in certain conditions if you raise the centerboard. The keel alone will produce enough lift and you'll have less drag.  You won"t make as much headway but you may not need to.

Good luck!

Lee
1999 Rhodes22  AT EASE
Claytor Lake, VA






See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting