The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

Todd Tavares



Rhodes22-list Digest, Vol 4389, Issue 1

2021-10-20; 11:05:03 EDT

Member Since

2002-09-10

Posts: 976

Ric,

It must be that the front lower stays attached with the chain extensions are to keep the mast from leaning beam wise??

I have a self-made system and attach the forward lowers to the crane pole, and have wondered the same thing.

I  use baby stays attached to eyelets on the mast below the spreader brackets to keep the mast in line. This method was outlined in one of the early GB instructions. My system utilizes the trailer winch cable attached to the crane pole. The baby stay lines run under the cabintop handrail aft of the center mount fitting then forward and tied off to the trailer tower next to the winch with a tautline hitch. I can easily adjust the tension in flight, and if the mast tries to lean sideways while cranking, I can just put a bit of pressure down on the opposite baby stay and bring the mast back/keep it in line.

I have purchased a small at electric winch at Harbor Freight that I will try next spring
It has a remote fob so I can stand on the foredeck and control the mast by and foresail/furler without having to stay at the winch. It should make the process much easier single handed...hopefully.

Todd T

See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting