Update on IMF outhaul/furling running rigging changes made over the winter
2021-12-08;
07:05:38 EST
Member Since
2020-01-16
Posts: 133
I've taken out, and replaced, a few screws on the boom and they look like simple sheet metal screws (i.e. threads all the way to the head). Having few mechanical skills and with a high degree of laziness I"m going to go with metal screws, probably the "self-tapping" variety. I'll report on the outcome. Probably do the work next week since our club is racing this week (its good to be in Florida!)
--Reuben
Reuben Mezrich
Pelican Cove in Sarasota and Back Bay, Boston
Cell: 410-499-8922
On Tue, Dec 7, 2021 at 9:18 PM Jesse Shumaker <
jesse.laten.shumaker at gmail.com> wrote:
> I decided to tap the threads because of my experience the prior summer when
> I added more small cleats to the bottom of the boom. That time I drilled
> pilot holes and used stainless sheet metal screws but it was hard to avoid
> stripping them. That inspired me to get a tap and die set (an excuse for
> more tools!) and give that a try. I may have done more work than
> necessary, which often seems to be the case :)
>> On Tue, Dec 7, 2021, 8:09 PM Peter Nyberg <peter at sunnybeeches.com> wrote:
>> > I'm pretty sure that's what I did, or I might have even used wood screws.
> >
> > I probably got the idea that this would be OK because every piece of
> > hardware attached to the mast or boom that was put in place by General
> > Boats that I have removed was attached by screws, not bolts. I can
> identify
> > with the notion that because tapping threads into the boom is more work,
> it
> > must be the better solution, but I'm not at all certain that's actually
> > true.
> >
> > Also, I don't know if it's significant that in this case the forces
> > applied to the screws (or bolts) would be sheer, not tension (I think I'm
> > using those terms correctly).
> >
> > Perhaps Roger would care to comment.
> >
> > --Peter
> >
> > > On 2021-12-07, at 18:49:55 EST, Reuben Mezrich wrote:
> > >
> > > Glad you mentioned this… I was just going to use sheet mettal screws
> > >
> > > Reuben Mezrich
> > > Cell: 410-499-8922
> > >
> > >
> >
> >
>
×
Message to Webmaster:
To use your email application to send a messsage to the webmaster rather than this form,
.