> On Jan 2, 2022, at 4:22 PM, Scott Andrews via Rhodes22-list <rhodes22-list at rhodes22.org> wrote:
>> Mine is the same as David’s and has worked great.
> Scott
>> Sent from my iPhone
>>> On Jan 2, 2022, at 12:38 PM, David Bradley <dwbrad at gmail.com> wrote:
>>>> You know what, yes, they are. So focused on not confusing Starboard the material with starboard the side that I neglected not to write starboard. Not my last mistake of 2022.
>>>> Dave
>>>>>> On Jan 2, 2022, at 10:55 AM, Michael McKay <mm.bizlist1 at gmail.com> wrote:
>>>>>> Thanks Dave. One question, aren’t your tank and outboard on the port side of the boat?
>>>>>> Michael McKay
>>> (630) 209-2054 (m)
>>>>>> Sent from my iPhone
>>>>>>>> On Jan 2, 2022, at 9:24 AM, David Bradley <dwbrad at gmail.com> wrote:
>>>>>>>> Hi Mike. On my boat there is a GBI-installed strip of Starboard on the cockpit sole under the starboard seat that creates a ridge that matches a groove in the gas tank. There is a line and pin that sits in the groove on the top side of the tank and attaches to the Starboard on each end. I’ve never had a problem with the tank moving.
>>>>>>>> Dave Bradley
>>>>>>>>>>>>> On Dec 31, 2021, at 6:16 PM, <mm.bizlist1 at gmail.com> <mm.bizlist1 at gmail.com> wrote:
>>>>>>>>>> Happy New Year fellow Rhodies!
>>>>>>>>>> I have found that my gas tank has a tendency to slide out from under the
>>>>> seat when I'm heeling hard to starboard. I want to install a retaining
>>>>> strip on the cockpit sole to prevent that.
>>>>>>>>>> I am aware of the more sophisticated solutions that have been documented
>>>>> previously in the forum for installing a metal retaining rod under the
>>>>> seats--I had actually planned on doing that. However, I subsequently found
>>>>> that the 30qt Weathertight Totes from the Container Store (Item # 10050818)
>>>>> don't slip out even when at maximum heal. So I'd rather just install a
>>>>> simple retaining strip for the gas tank.
>>>>>>>>>> My plan is to first drill larger holes than needed, fill those with
>>>>> thickened epoxy, and then drill through the epoxy to attaching the retaining
>>>>> strip. Does this sound reasonable?
>>>>>>>>>> Thanks,
>>>>>>>>>>>>>>> Mike McKay
>>>>> s/v Liber (2006/2018)
>>>>> Allatoona Lake
>>>>> Acworth, GA
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>
×
Message to Webmaster:
To use your email application to send a messsage to the webmaster rather than this form,
.