> On Jan 17, 2022, at 5:46 PM, Peter Nyberg <peter at sunnybeeches.com> wrote:
>> Larry,
>> My mainsail furling and unfurling lines are 1/4". Last year, I replaced my jib furling line with 3/16" because I would sometimes run out of room on my CDI furler spool with 1/4" line. As I recall, 3/16" is what CDI recommends for this furler, but even with the thinner line, I still sometimes run out of room on the spool before the jib is fully deployed. Operator error, I'm sure.
>> I don't know as much as I should about the various types of lines available. I do tend to use Defender as a source, and often choose something from the New England Ropes Sta-Set offerings largely because most diameters are available in a wide variety of colors. These lines seem to be performing well.
>> HTH,
>> --Peter
>>>> On 2022-01-17, at 16:52:56 EST, Larry Gioia wrote:
>>>> The gooseneck emails reminded me that I need to replace the Mainsail and furling
>> control lines on my ‘86 R22. Peter has an excellent episode 25 video on how to
>> do this, but my question is what type of line is that, where can I order it from
>> and what is the thickness? 1/4”? The previous owner of my ‘86 was not familiar
>> with Rhodes rigging, used the wrong type of line, too thick (binds up) and too
>> short to thread through the boom. Peter you’ve directed me to Defender Marine
>> for other lines and I like ordering from them but can’t find that type of line
>> on their site.
>>>>>> Thanks!
>>>>>> Larry
>>>> ‘86 R22 still unnamed!
>>>> Keystone Lake
>>>> Odessa, FL
>>>>>>>
×
Message to Webmaster:
To use your email application to send a messsage to the webmaster rather than this form,
.