The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

Michael McKay



Tiller-Outboard Interconnect question

2022-01-19; 12:14:00 EST

Member Since

2020-11-17

Posts: 211

Bob, you will have to remove the tiller connection at all times except when maneuvering under power.

I originally thought the tiller to outboard connection would be a great feature, but I found that it was not useful or necessary in my case for two reasons:

1) The effective range of motion using the tiller connection on my outboard (Mercury 8hp) is too limited.  I can make much sharper turns with just the rudder when under power.  On rare occasions, I manually swivel the outboard when maneuvering in close quarters at slow speed.  It's a bit awkward, but not that difficult.

2) The resistance introduced by the outboard swivel clutch is very high, making it very difficult to move the tiller.  You can release that clutch when the outboard connection is in place, but that just makes the whole process cumbersome and you have to remember to re-engage the clutch afterwards.


Mike McKay
s/v Liber (2006/2018)
Allatoona Lake
Acworth, GA



See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting