The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

ROGER PIHLAJA



Tiller-Outboard Interconnect question

2022-01-21; 10:05:58 EST

Member Since

2002-08-01

Posts: 1438

Bob & Jeff,

The fastest way to make your Rhodes 22 turn a corner under power does not involve the tiller-outboard connecting linkage.

Assume you want to make a hard turn to port in the minimum possible area.  You setup by motoring along  slowly, say 2-3 knots, just enough speed to maintain rudder steering control.  Put the desired slip about 1 boat length away to port.  Assume you are going for a port side docking against a finger pier.  Shift the motor into neutral and turn the motor’s tiller all the way the port.  When your bow is even with the end of the finger pier, do the following in quick succession.  Shift into reverse, apply full throttle, and put the boat tiller hard over.  Hang on to something!  The boat will yaw 90 deg to port in about 1 sec!  It will simultaneously slow down, side slip about 1/3 boat length to starboard, and drift forward about ¾ boat length.  At about 45 deg of yaw, throttle the motor back to idle and then shift into neutral.  Straighten out the outboard tiller and the boat tiller.  The boat’s rotational inertia will complete the 90 deg of yaw.  Note, the hull and shoal draft keel produce a lot of drag vs. yawing.  The boat will use up it’s rotational inertia very quickly.  With a little bit of practice, you will end up virtually stopped at the entrance to the slip, with your bow pointed into the slip, and about 12 inches of clearance between your port side rub rail and the pier.  Now shift into forward and idle into your slip.   For a starboard quick turn, simply turn the motor tiller to starboard before shifting into reverse.

This technique is also very useful to force the bow to yaw into strong cross wind &/or cross current.  It’s also very useful for a stern to docking.

It’s best to practice this maneuver in open water a few time before attempting it in a crowded marina.  You will be impressed with how much faster the boat will yaw when the motor is simultaneously applying sideways and reverse thrust to the transom.  Obviously, the tiller-outboard connecting linkage cannot be connected to execute this maneuver.

Try this technique, it will make you look like a docking genius!

Roger Pihlaja
S/V Dynamic Equilibrium

Sent from Mail<https://go.microsoft.com/fwlink/?LinkId=550986> for Windows

From: Bob Garrant<mailto:bgarrant at gmail.com>
Sent: Friday, January 21, 2022 5:43 AM
To: The Rhodes 22 Email List<mailto:rhodes22-list at rhodes22.org>
Subject: Re: [Rhodes22-list] Tiller-Outboard Interconnect question

That’s what I’m looking for. My slip is in a corner so i only have 90° To maneuver in rather than 180°. So every little bit helps.
I appreciate all the guidance from those way more experienced than I am with this vessel.
Bob

See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting