The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

ROGER PIHLAJA



Tiller-Outboard Interconnect question

2022-01-22; 11:06:49 EST

Member Since

2002-08-01

Posts: 1438

Bob,

Boy that’s a challenging slip!  I hope the marina gave you a discount for the royal PITA factor.  If there is much of a cross wind, it must be a real bear, especially stern to.  If I encountered something like this while cruising (i.e. no practice!), I think I would drop someone on the end of the pier with the dock lines and use the lines to warp the boat in.

I’ve never attempted this; but, in principle, there is no reason why you can’t apply reverse thrust with the motor tiller hard over to port for a little longer to make the boat turn 180 deg in it’s own length.  I think I would start the turn when my bow was even with the finger pier on the starboard side as per your diagram.  But, instead of a 90 deg turn to port, I would turn 180 deg to port.  I would pick up the dock line off the piling as I was backing into the slip.  Instead of having to make a critical 90 deg turn in reverse, you would only need to make minor course corrections as you back into the slip.  Your major maneuver is done to port and away from the docks, thus giving you maximum space and time to react if something goes wrong.  Never the less, I would have some helpers standing by on the docks to catch you while I practiced this maneuver a few times!

Roger Pihlaja
S/V Dynamic Equilibrium





Sent from Mail<https://go.microsoft.com/fwlink/?LinkId=550986> for Windows

From: Bob Garrant<mailto:bgarrant at gmail.com>
Sent: Friday, January 21, 2022 6:24 PM
To: The Rhodes 22 Email List<mailto:rhodes22-list at rhodes22.org>
Subject: Re: [Rhodes22-list] Tiller-Outboard Interconnect question

Hi Roger,
Thanks for the guidance on this.
The challenge that I have is this.
I leave my boat stern-in in the slip.
To do this, I usually head directly at the slip, then 90° to port, stop just past my slip, and reverse 90° to starboard and back into the slip.

My primary objective is to make a tight 90° turn to port and have my starboard quarter snug up to the piling. I grab a dock line from that piling and then reverse and pivot into slip, stern in.

See the attached image for a better illustration (perhaps). Basically, I’m looking to make as tight a 90° as possible.

Bob


image_6483441.JPG
See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting