The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

Lowe, Rob



Bilge Pump Questions

2022-01-24; 12:46:13 EST

Member Since

2003-04-15

Posts: 1937

Chuy,
Here is a pretty good article from Boat US on installing a bilge pump.  It also discusses a second, 'i don't want my boat to sink' pump.
https://www.boatus.com/expert-advice/expert-advice-archive/2012/july/installing-bilge-pump

Also attached is a photo from my previous boat that had a sump pump.  Note how high the white pipe goes.  This is the anti-siphon loop that Roger describes.  Most of the sumps are tee'd into the sink drain as shown.

Rob
[https://www.boatus.com/-/media/expert-advice-archive/2012/july/installing-bilge-pump/__twitter.ashx]<https://www.boatus.com/expert-advice/expert-advice-archive/2012/july/installing-bilge-pump>
Installing a Bilge Pump | BoatUS<https://www.boatus.com/expert-advice/expert-advice-archive/2012/july/installing-bilge-pump>
A bilge pump big enough to deal with a real emergency will do a poor job of keeping the bilge dry because the water in the discharge hose drains back into the bilge when the pump shuts off.
www.boatus.com



sink drain.jpg
See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting