The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

Mike Riter



Tiller pilot - Am I overthinking this?

2022-03-03; 17:30:09 EST

Member Since

2018-03-19

Posts: 105

I just purchased an ST1000 Tiller Pilot from Defender and after reading the instructions several times, I'm left scratching my head about a critical part of the installation.

According to the directions, with the tiller centered, I should have 23.2" from the gunwale mounting pin to the center of the tiller handle. I premeasured everything and ordered a 3" extension and a 5" extension.

I assumed the tiller pilot would come from the factory with the pushrod extended half way through it's length so that it would move equally to port and starboard. Mine came with the pushrod fully retracted. The directions say nothing about powering it up and extending the pushrod to the halfway point.  Which is what I just did. Since (my) logic dictates this is correct, I'm going to attempt to install it this way.

So, my sanity check type question to those of you who've installed them; did your tiller pilot come with the pushrod extended to the center or did you have to do something similar to what I did.

The service dept. at Defender was no help and Raymarine wouldn't answer the phone.

I've attached a photo of what it looked like out of the box.

Mike Riter
SV Emma B

IMG_1652.JPG
See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting