The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

ROGER PIHLAJA



Tiller pilot - Am I overthinking this?

2022-03-03; 18:38:58 EST

Member Since

2002-08-01

Posts: 1438

Hi Mike,

The Tiller Pilot is shipped with the pushrod fully retracted in order to make it as physically small as possible.   When I stow my Tiller Pilot, I also retract the pushrod as far as possible.  I do this to protect the pushrod and make the unit as small as possible.

On p 35 of the Owner’s handbook, there is a drawing that shows the basic installation.  There is a front elevation and an overhead plan view.  Both drawings show the pushrod halfway extended and making a 90 deg angle vs the centered tiller.  Although the text does not explicitly state it, you correctly deduced the “home” position of the pushrod is halfway extended.  This must be true in order for the Tiller Pilot to be able to move the rudder both port and starboard.  So, Dimension A is the length when the unit is at home position.

The Owner’s Guide gives the mounting socket centerline to tiller pin centerline (“Dimension A”) as 589 mm (23.2 inch).  The owner must install pushrod extensions to lengthen the pushrod in order to make up the difference between Dimension A and the actual, as installed, distance between the mounting socket and the tiller pin on your boat.


IMG_1652.JPG
See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting