The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

Mike Riter



Tiller pilot - Am I overthinking this?

2022-03-04; 13:53:34 EST

Member Since

2018-03-19

Posts: 105

Well Whew! Thanks Roger and Peter. In keeping with the notion no 2 Rhodes are created the same, I found the drop from the bottom of my fiberglass tiller to be level with the center of the push rod is 4".  And with both the 5" and 3" extensions in place the rear pivot pin on the tiller pilot (square from the tiller) just reaches the point where the curve from vertical to horizontal on the starboard gunwale. Now I'm debating on whether to return the 3" adapter and get a 4" adapter to add another inch or take advantage of what I'm betting is thicker fiberglass at the current location.

In anticipation of the wiring, I pulled out the switch panel and found a tangle of unlabeled wires with multiple attachments to many of the switches. So all that gets to be updated. Yaa.

The wiring generates another question, I'm planning to tie this into my Garmin chartplotter via NMEA 0183 and may add wind data to this one day as well. Has anyone set up separate buss bars just for the NMEA? Any advice + or - on that would be appreciated.

Maybe I'm biased because I'm a R22 owner, but of the sailing and cruising forums I follow, this is the friendliest and most helpful of them all. I really appreciate everyone here!

Mike Riter

SV Emma B




See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting