< prior
Back to Month
Go to Thread
2022-03-21; 14:07:14 EDT
Member Since
2002-08-01
Posts: 1438
Rick, Is this a joke? With you I never know. Roger Pihlaja S/V Dynamic Equilibrium Sent from my iPhoneSee the original archive post
> On Mar 21, 2022, at 1:22 PM, Rick Lange <sloopblueheron at gmail.com> wrote: > > Hi Roger, > > The IMF mast does not rake. It stands for In Mast Furling. > > Regards, > > Rick Lange > > >> On Sun, Mar 20, 2022 at 8:46 AM ROGER PIHLAJA <roger_pihlaja at msn.com> wrote: >> >> Mike, >> >> Here’s an experiment to determine if you have too much mast rake. >> Assuming light to moderate wind so you can put up full sail, establish a >> close hauled point of sail, and trim both sails as good as possible. Take >> note of how much weather helm you have. Assuming you have the IMF >> mainsail, reef the mainsail a small amount, say 6 inches. Reestablish a >> close hauled point of sail and trim the sails as good as possible. You >> should now have less weather helm or maybe neutral or even lee helm. Keep >> reducing mainsail area until you have eliminated all the weather helm. >> >> By shortening the forestay, the weather helm can be tuned out of the rig. >> I like the helm to be neutral to very slight lee helm in light air. As the >> wind strength builds, the hull is going to heel over no matter how much >> rail meat you pile onto the windward rail. I won’t go into the physics of >> why and how; but, the asymmetric wetted shape of the heeled over hull just >> naturally generates weather helm. You counter this tendency towards >> weather helm by reducing mainsail area. This moves the rig’s center of >> effort forward and reduces weather helm. You want to leave the foresail at >> full area as long as you can keep the boat sailing on her lines and use the >> mainsail area to balance the helm. >> >> In light air, there is very little feel to the helm no matter how the rig >> is tuned. The easiest point of reference is to have the rig tuned for >> neutral helm, especially for a novice helmsman. So, even though the >> helmsman isn’t getting any feedback thru the tiller, he/she knows to simply >> center the tiller, and the boat will go straight. As the wind strength >> builds and sail area is not reduced, the hull will begin to heel over, and >> weather helm will build. The helmsman is now getting plenty of feedback >> thru the tiller. If the weather helm gets to be tiresome; then, the >> mainsail area can always be reduced to take the pressure off the tiller. >> Even a few degrees of rudder angle off center develops an amazing amount of >> drag. This slows the boat down and reduces pointing ability. Remember, >> the boat is making leeway even when the tiller is centered, and this leeway >> is enough for the shoal draft keel, centerboard, and rudder blade to work >> together to develop the required lift for the boat to be able to point. >> >> Roger Pihlaja >> S/V Dynamic Equilbrium >> >> Sent from Mail<https://nam12.safelinks.protection.outlook.com/?url=https%3A%2F%2Fgo.microsoft.com%2Ffwlink%2F%3FLinkId%3D550986&data=04%7C01%7C%7C3d0483627edb440749cb08da0b5f55af%7C84df9e7fe9f640afb435aaaaaaaaaaaa%7C1%7C0%7C637834801342317279%7CUnknown%7CTWFpbGZsb3d8eyJWIjoiMC4wLjAwMDAiLCJQIjoiV2luMzIiLCJBTiI6Ik1haWwiLCJXVCI6Mn0%3D%7C3000&sdata=pj5DU32tWH%2B7tD5D5V7UY6fGG2Y%2FPQNmMwuhdJvXJw8%3D&reserved=0> for Windows >> >> From: ROGER PIHLAJA<mailto:roger_pihlaja at msn.com> >> Sent: Friday, March 18, 2022 7:32 PM >> To: The Rhodes 22 Email List<mailto:rhodes22-list at rhodes22.org> >> Subject: Re: [Rhodes22-list] How to improve Rhodes 22 upwind performance? >> >> Mike, >> >> A couple of things to check: >> >> 1. Is your centerboard all the way down? >> >> 2. Is your rudder blade all the way down? >> >> 3. In 5-15 knots of wind, you should use the mainsheet and traveler to >> center the boom. Make certain the boom is not rising up and there isn’t >> too much curl on the leech. Make certain the mainsail foot out haul is >> tight. Without battens, there is only so much you can do with mainsail >> shape; but, this will set you up to do the best that is possible. >> >> 4. Use your backstay adjuster to get the sag out of the forestay. It >> takes quite a lot of tension on the backstays to remove the forestay sag. >> Don’t be afraid of cranking on the backstay adjuster. A mast head rig >> needs the forestay to have little sag in order to properly form an >> efficient slot with the mainsail. >> >> 5. Refer to my rig tuning procedure in the archives to adjust the tension >> in the standing rigging. >> >> The Rhodes 22 sails best to weather if it is regarded like a big sailing >> dingy, as upright as possible. There should be zero to very slight weather >> helm. If you have too much weather helm; then reduce the mast rake angle. >> ie Make the mast rake more perpendicular to the deck. >> >> My guess is you have too much mast rake, which is giving you a lot of >> weather helm, and killing your ability to point to weather. >> >> Hopefully, these suggestions help. >> >> Roger Pihlaja >> S/V Dynamic Equilibrium >> >> Sent from my iPhone >> >>>> On Mar 18, 2022, at 1:49 PM, mm.bizlist1 at gmail.com wrote: >>> >>> Hi All, >>> >>> Now that I've been sailing my Rhodes for about a year, I'm starting to >> focus >>> on getting the best performance out of her. While I mostly sail for >> fun, I >>> do race every couple of weeks and want to be more competitive. In >>> particular, I have found that she does not go to windward very well for >> me. >>> >>> >>> I have a 130 genoa and the IMF mainsail. Until very recently, I have >> been >>> routing the jib sheets outside of the outer shrouds and handrails. That >>> limits how much I can trim the genoa. Consequently, I can only tack >> through >>> about 100-120o. >>> >>> Recently, I tried running the jib sheets between the outer shrouds and >> the >>> inner shrouds. That definitely improved my pointing ability >> significantly >>> at the expense of less than optimal headsail shape on some off wind >> points >>> of sail. However, this configuration lets me use my jib cars to adapt to >>> wind strength and whether or not I am partially reefed. I think this >> will >>> retain the ability to use a whisker pole on downwind legs. >>> >>> I did briefly try both of the inboard jib sheet fairlead/cleat >> alternatives >>> but using those would seem to require having a second set of jib sheets >> and >>> probably going on the foredeck to switch between them after rounding a >> mark >>> (I often race solo). Also, those options eliminate the ability to >> control >>> the sheeting angle to the clew with the jib cars. >>> >>> I'd greatly appreciate your thoughts and comments about what you have >>> learned about how to optimize your boat's performance. >>> >>> Thanks, >>> >>> >>> Mike McKay >>> s/v Liber (2006/2018) >>> Allatoona Lake >>> Acworth, GA >>> >>> >> >>
To use your email application to send a messsage to the webmaster rather than this form, .
Your post is being sent... 