The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

Michael McKay



How to improve Rhodes 22 upwind performance?

2022-03-22; 12:37:54 EDT

Member Since

2020-11-17

Posts: 211

Roger,

Thanks again for taking the time to respond so thoughtfully.

1) My jib cars are all the way forward.  I agree that the jib tracks don't provide the proper range of positions with the 130% genoa.  In regards to optimum jib size for the Rhodes 22, I had posted that question to the forum before I bought my Rhodes, and there seemed to be some consensus that a 130 was the best compromise.  I would like to sail a boat with one of the larger sails, but I imagine they would be harder to tack in light air (typical of my area), although having more sail area would also be beneficial.  My genoa has telltales without windows, but in most cases you can easily see the leeward telltale through the sail.  Because of the limitations imposed by the jib tracks, I have limited control over the twist in the headsail.

If you had it to do over again, would you stay with the 150 genoa or go with a different size?

2) I hadn’t realized that there is a factory option for additional jib tracks.  I will check with Stan regarding those, but I suspect the installation process would be non-trivial.  Based on your comments, it also seems that they would only be useful when I partially furl the sail in heavier wind and wouldn't help give me better sheeting options with the full sail.

3) I am slightly familiar with barber haulers.  They are generally used off the wind to help hold the clew further outboard with less twist than would be possible with the inboard jib fairleads.  I have thought about how to install a barber hauler on my Rhodes but haven't attempted it.

4) My mainsail is definitely fully unfurled.  The outhaul allows me to pull it out within a couple of inches of the end of the boom.  I also have concerns about the position of the draft--it also seemed too far aft to me, but the Rhodes running rigging doesn't give one much control over that.  Has anyone ever tried using a Cunningham with the IMF sail?  Would that be potentially dangerous?

5) My main does have a leech line, which is fully eased.  The sailmaker speculated that a prior owner had tightened it too much for too long which may be why it is permanently cupped.  I'm beginning to see that a new main could be required to solve multiple issues.  By the way, I had tightened the outhaul because the wind gusts had picked up quite a bit--it started out much looser.  Your discussion about the "groove" is spot on.

6) Finally, have you or anyone else tried routing the jib sheets between the shrouds as I described?  For me it was a positive change, but it seems I have other issues that need to be addressed to improve my windward performance.

Thanks Roger!


Mike McKay
s/v Liber (2006/2018)
Allatoona Lake
Acworth, GA



See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting