The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

Graham Stewart



Deck Joint repair question

2022-03-27; 21:36:00 EDT

Member Since

2005-04-29

Posts: 814

Can't say I have many pictures of the fix for the hull-deck joint repair  but have attached what I have. As I mentioned before I cut back the flange on the upper liner so I could get access to the inside joint which I then filled with thickend epoxy and covered with several layers of fiberglass cloth. That made the whole boat more rigid and certainly stopped any leaks but, like most of what I did, was grand overkill.

I used simple tools to remove the old sealant after removing the old rub rail. I don't think it is possible to remove the rub rail without destroying it. The new rub rail was made by Tessilmayer. The new rail cap goes over a track that was screwed and riveted through the joint. Why did I use both screws and rivets? God knows.

Graham Stewart
Agile, Rodes 22, 1976
Kingston Ontario








tools for removing sealant in hull deck joint June 2016 (3).jpg

Hull - Deck join rebuild 2009 (3).jpg

Hull - Deck join rebuild 2009.jpg

Reb rail installed- Tessilmare July 2016.jpg
See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting