The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

Joe Dempsey



Size of Centerboard hole

2022-05-14; 17:39:58 EDT

Member Since

2022-05-14

Posts: 216

By the way, when it comes to replacing the cap and gasket, Stan has very specific instructions. There are 50+ 316 SS Machine screws and fender washers  and backing nuts securing the rubber gasket. It does not require sealant. If properly fastened and the machine screws carefully tightened, it will remain water tight. Do not over tighten! If you cannot find Stan's instructions, let me know and I will post them.

Joe Dempsey
SV Respite
Deltaville, VA


Bilge-CB Trunk After.jpg
See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting