The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

Graham Stewart



Attaching the centerboard housing cap

2022-05-16; 16:23:16 EDT

Member Since

2005-04-29

Posts: 814

Here is a simple suggestion that makes installing the housing cap bolts easier.

After installing the cap repeatedly, I found that if I used hex head bolts and inserted them from below with the nuts on the top I could hold the  head easily with a box head wrench and then use an electric drill with a torque adjustment to install the nuts. The torque adjustment can be set to the level you need and then will tighten all of the nuts evenly and in seconds. I would NOT use an impact driver as that might tighten the nuts too much. Installing the bolts upside down was much easier than trying to reach under the flange to thread the nuts on and then having very limited room for the wrench to swing. Repeating that process 55 times can be a tad frustrating to say the least. Just make sure that the bolts are not so long that they hit the underside of the floor boards.

Graham Stewart
Agile, Rodes 22, 1976
Kingston Ontario







See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting