The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

Steven Alm



Attaching the centerboard housing cap

2022-05-16; 18:02:04 EDT

Member Since

2007-05-08

Posts: 600

Graham, thanks for the tip but the holes in my gasket are just snug enough so that I have to screw the bolts in. They won't just push through, so I don't think I could get them in from below. If I thought I'd be doing this much more I'd drill out the gasket holes a bit and then I could use your method for sure. It certainly is a challenge to get the washer on and then thread the nut on, especially on the ones at the back. And I'm using nylock nuts so you can only finger-tighten them a few turns. Then I get a box wrench on the nut below and use the ratchet on top. I haven't tried the drill torque clutch because some of them require more torque because of some of the gasket holes being so tight that it messes with the needed torque — and I want to be careful not to over tighten them so I baby each one carefully by hand. Definitely not something I want to do every day!!

Slim
Fandango

See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting