The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

Graham Stewart



Attaching the centerboard housing cap

2022-05-16; 23:32:10 EDT

Member Since

2005-04-29

Posts: 814

Slim:

You make good points that made me realize that I had omotted some detail that might be relevant.

In my case I used a punch to cut clean but snug holes in the gasket for the bolts. I also used lock washers rather than lock nuts as I think it is easier to torque the nuts properly with the lock washers and they are certainly easier, and cheaper, to install. I prefer to tighten the nut rather than hold it and tighten the head but I don't know whether that actually makes any difference. Finally, I install all of the bolts loosely before tightening any of the nuts and when I do, I start at the centre and tighten them in sequence towards either end.

Graham Stewart
Agile, Rodes 22, 1976
Kingston Ontario







See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting