The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

Steven Alm



Attaching the centerboard housing cap

2022-05-17; 11:19:33 EDT

Member Since

2007-05-08

Posts: 600

Thanks for the clarification, Graham. That all makes a lot of sense. I too tighten the cap down the way I learned to tighten the heads on a V8 — starting from the middle. I tighten to what I feel is about 90% then start over at the middle and give each one a final turn. I don't think you can take too much care in this. In fact I'll be doing this very thing today. I got all the fasteners in place and finger tight a couple days ago, then had another task that took me off the boat, so I'll try to finish up today. I hope to splash next week some time and avoid the Memorial Day crowds at the ramp. I still have a perplexing electrical issue (not my strong suit at all) but that can wait. I'll probably post some questions about that later. Thanks again!

Slim
Fandango

See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting