The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

Joe Dempsey



Attaching the centerboard housing cap

2022-05-17; 12:57:23 EDT

Member Since

2022-05-14

Posts: 216

I consulted the List and Stan during my project in 2019. I had suspected the gasket as a source for much of the water and dampness in the bilge.  I reported the following on replacing the CB gasket.



Removing the CB Cover and Gasket is fairly easy. General Boats specification calls for a ¼” x 1-1/4” -20 316 grade Stainless Steel Hex Bolt, locknut and 2 fender washers for each of 50+ holes. A previous owner had omitted the 100 fender washers. The gasket showed considerable dry rot and a hole in the middle of the gasket about 1” from the forward end of the cap. (Seen in the circular shaped stain in the top right photo).  There were rust stains around most of the screws, so they may not have been 316 Stainless. To my amazement, I found that the SS fasteners that West Marine sells are 8-18 grade. They are really unsuitable for the marine environment. For a few cents more, you can get 316 grade if you look for it.  I replaced all of the hardware with ¼” x 1-1/4” 316 SS Machine bolts, fender washers and lock nuts purchased from McMaster-Carr on line.

Upon removing the CB Cover. Remove the pendant tube and clamp. Lift the CB Cover and lay it upside down and take a photo of the pendant routing for reference when re-assembling. “Respite’s” CB is the original design (same shape as rudder) and originally was configured with the 4 block lift mechanism. It was changed at some point to a single mini-block on the CB routed directly from the forward bale in the raised portion of the CB Cover, through the block to the 1” rod in the aft of the cover and through the hole leading to the pendant tube to the cockpit. (See Sketch). Whoever did this conversion did a pretty sloppy job leaving two of the original mini blocks in a cluster at the bale where the pendant is tied off. The pendant was in good shape but configuration of the pulley system had been changed, most likely during “recycling” by General Boat. One of the original two mini blocks on the trailing edge of the CB had been eliminated and both of the two blocks in the trunk cap had been eliminated (although they were still present) I obtained a replacement gasket through Chris Cowie, a Rhodie at VoilierYachts in White Plains, MD.( If you want to buy your own gasket, purchase neoprene.) I took my CB cap to them so they could get the bolt holes properly aligned in the right pattern. Once I had the new gasket, re-assembly of the gasket and CB Cover was the reverse. I tightened the hex screws barely snug at first and then gradually tightening, side to side and then front to rear and finally snugging them down in the same sequence, taking care not to over tighten.(Do not tighten by alternating front to rear or there is a chance of a “bubble” occurring in the gasket.)  Once you launch for the first time, check for leaks and torque the bolts as necessary, but always allow for future tightening.  I’m in my third season (2021) and it hasn’t leaked a drop!  This is a good time to paint your bilge. I did so with Petit Bilge Paint. Be sure to completely clean, scrub a rub down the bilge with the solvent recommended by Petit. I used two coats allowing to dry according to the instructions.



See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting