Sorry, the part of the question regarding the IMF was related to removing the bolts that hold the spreaders not the washer/shims.
How about the spring loaded pin that holds the pop top carriage?
David Berg
Blue Loon
Minneapolis
From: Rick Lange <sloopblueheron at gmail.com>
Sent: Wednesday, May 18, 2022 1:57 PM
To: DAVID BERG <davidmberg at mac.com>
Cc: The Rhodes 22 Email List <rhodes22-list at rhodes22.org>
Subject: Re: [Rhodes22-list] Spreader bolt / washer - pop top slider pin
No, they have nothing to do with furling. How do you mean my answer isn't correct?
Regards,
Rick Lange
On Wed, May 18, 2022 at 2:53 PM DAVID BERG <davidmberg at mac.com <mailto:davidmberg at mac.com> > wrote:
Rick,
I’ve seen that answer here before, but it doesn’t seem correct! Perhaps. Does the IMF have to come out to replace them?
Dave
From: Rick Lange <sloopblueheron at gmail.com <mailto:sloopblueheron at gmail.com> >
Sent: Wednesday, May 18, 2022 1:50 PM
To: DAVID BERG <davidmberg at mac.com <mailto:davidmberg at mac.com> >; The Rhodes 22 Email List <rhodes22-list at rhodes22.org <mailto:rhodes22-list at rhodes22.org> >
Subject: Re: [Rhodes22-list] Spreader bolt / washer - pop top slider pin
Hi David,
Your washers are "tapered" because they have been deformed. Any hardware store has nylon replacements.
Regards,
Rick Lange
On Wed, May 18, 2022 at 2:46 PM DAVID BERG via Rhodes22-list <rhodes22-list at rhodes22.org <mailto:rhodes22-list at rhodes22.org> > wrote:
Good afternoon,
I need to replace the tapered washers and possibly the bolts for my spreaders. I only inspected briefly, and in the rain, but it appears that the IMF must be removed to do this work. I'm assuming these are Dwyer parts.
I also need a new spring detent pin, or whatever you call the thing that releases the pop top carriage (or the boom carriage for that matter).
Any advice would be greatly appreciated.
David Berg
Blue Loon
Minneapolis
×
Message to Webmaster:
To use your email application to send a messsage to the webmaster rather than this form,
.