The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

Michael D. Weisner



Spreader bolt / washer - pop top slider pin

2022-05-18; 16:09:45 EDT

Member Since

2006-06-11

Posts: 1826

Hi David,

The nylon (white) pieces have not been "deformed". They were manufactured to match the curve of the mast so that the spreader is straight out from the mast, not swept back. They actually look fine. Why do you want to replace them?

To replace the bolt, tapered shim, washer, etc., you need access to the inside of the mast. The mast must be lowered and the IMF removed (slid out the bottom). An open end box wrench is needed inside and a deep socket wrench inside the 1" tube into which the spreader is inserted.

I am not sure what "pin" you need. I attached a picture (look all the way down to the bottom of the email to find the link to the image). If this is what you are looking for, you should speak to Stan at General Boats (or Charles) for the replacement parts. Replacement will also require lowering the mast as the components are inserted from the bottom.

Mike
s/v Wind Lass ('91)
Nissequogue River, NY
I’d rather be sailing :~)


IMG_0740.JPG
See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting