-----Original Message-----
From: Rhodes22-list <rhodes22-list-bounces at rhodes22.org> On Behalf Of Joe Dempsey
Sent: Saturday, May 14, 2022 5:40 PM
To: 'The Rhodes 22 Email List' <rhodes22-list at rhodes22.org>; 'ROGER PIHLAJA' <roger_pihlaja at msn.com>
Subject: Re: [Rhodes22-list] Size of Centerboard hole
By the way, when it comes to replacing the cap and gasket, Stan has very specific instructions. There are 50+ 316 SS Machine screws and fender washers and backing nuts securing the rubber gasket. It does not require sealant. If properly fastened and the machine screws carefully tightened, it will remain water tight. Do not over tighten! If you cannot find Stan's instructions, let me know and I will post them.
Joe Dempsey
SV Respite
Deltaville, VA
-----Original Message-----
From: Joe Dempsey <jpd9668 at gmail.com>
Sent: Saturday, May 14, 2022 5:24 PM
To: 'The Rhodes 22 Email List' <rhodes22-list at rhodes22.org>; 'ROGER PIHLAJA' <roger_pihlaja at msn.com>
Subject: RE: [Rhodes22-list] Size of Centerboard hole
Photos I left off earlier post!
-----Original Message-----
From: Rhodes22-list <rhodes22-list-bounces at rhodes22.org> On Behalf Of chuy carreon
Sent: Saturday, May 14, 2022 12:02 PM
To: The Rhodes 22 Email List <rhodes22-list at rhodes22.org>; ROGER PIHLAJA <roger_pihlaja at msn.com>
Subject: Re: [Rhodes22-list] Size of Centerboard hole
Thanks Roger. The pivot hole was the hole that I was referring to.
Chuy Carreon
S/V AfterMath
> On May 14, 2022 at 9:32 AM ROGER PIHLAJA <roger_pihlaja at msn.com mailto:roger_pihlaja at msn.com > wrote:
>>> Unfortunately, there are also 2 holes in the centerboard. There is a hole which is a snug fit with a 1/2” OD shoulder bolt which is what the centerboard pivots on. Then, there is another hole near the trailing edge of the centerboard for the pennant. On my boat, this hole is 3/8” ID.
>> Roger Pihlaja
> S/V Dynamic Equilibrium
>>> Sent from my iPhone
>> > > On May 13, 2022, at 9:08 PM, Graham Stewart <gstewart8 at cogeco.ca mailto:gstewart8 at cogeco.ca > wrote:
> >
> > Hi
> >
> > >
×
Message to Webmaster:
To use your email application to send a messsage to the webmaster rather than this form,
.