The Rhodes 22 Discussion Group R22 Discussion Group

The Rhodes 22 Discussion Group


< prior

Back to Month

Go to Thread

Member Picture

Michael McKay



CB Gasket replacement and Tightening

2022-06-01; 17:23:45 EDT

Member Since

2020-11-17

Posts: 211

Joe,

This is very helpful.  In my boat there were no washers on the underside of the cap, just on the top.  I'll add bottom washers when I reassemble.
A few of the hex heads broke off during disassembly and there was evidence of corrosion, so I ordered all new 316 stainless hardware from McMaster-Carr (1 day delivery!).  I tried emailing Chris Cowie but his email bounced back.

My gasket seems to be in reasonable condition, but I planned on replacing it anyway.  However, I still haven't located neoprene sheet in the right size.  The gasket is 7.25" x 54.25" and is 3/16" thick.  I imagine that 1/4" neoprene would also work well and might be more forgiving if there are irregularities in the surfaces.  I am looking for soft 40A Duro, which is less common than the harder 60A.

If anyone has recently been able to get the gasket material, please let me know.  I've also reached out to Stan and Charles but haven't heard back yet.

Thanks for your help.


Mike McKay
s/v Liber (2006/2018)
Allatoona Lake
Acworth, GA



See the original archive post
×

Message to Webmaster:

To use your email application to send a messsage to the webmaster rather than this form, .



×

Post to the Rhodes 22 Email List:



×

Sending Post:

Your post is being sent... waiting